Filter
Top Products
24
Explanation of the panels
Explanation of the panels
GATE area
fig.ChEdtGate.eps
In this area you can operate the gate/expander that is provided
for CH1–32.
• DISP button
This accesses the GATE/EXPANDER popup where you can
make detailed settings. The button will light red while the
popup is shown.
You can turn the gate/expander on or off by holding down
[SHIFT] and pressing [DISP].
COMP area
fig.ChEdtComp.eps
In this area you can operate the compressor that is provided on
CH1–32 and the limiter that is provided on AUX1–8, MTX 1–4,
and MAIN L/R/C.
• DISP button
This accesses a popup where you can make detailed settings.
This will access the COMPRESSOR popup for CH1–32, or the
LIMITER popup for AUX1–8, MTX 1–4, and MAIN L/R/C. The
button will light red while the popup is shown.
You can turn the compressor or limiter on or off by holding
down [SHIFT] and pressing [DISP].
PAN area
fig.ChEdtPan.eps
• PAN knob
For CH1–32, this adjusts the pan. For AUX1–8, MTX 1–4,
MAIN L/R, it adjusts the balance.
AUX/MTX SENDS area
fig.ChEdtAux.eps
In this area you can adjust the send level from CH1–32 to the
AUX/MTX buses, or adjust the send level from AUX1–8, MAIN L/R/
C to the MTX buses.
• AUX1–AUX8 / MTX1–MTX4 buttons
These buttons select the AUX/MTX bus that will be the target
of the SEND LEVEL knob or the faders in SENDS ON FADER
mode.
You can turn the corresponding send switch on/off by holding
down [SHIFT] and pressing [AUX1]–[AUX8] / [MTX1]–[MTX4].
•
DISP button
This button accesses the AUX/MTX SENDS popup where you
can make detailed settings. It will light red while the popup
is shown.
•
SEND LEVEL knob
This adjusts the send level to the AUX/MTX bus selected by
the [AUX1]–[AUX8] / [MTX1]–[MTX4] buttons.
If an AUX or MAIN channel is selected, this will adjust the send
levels to MTX1–4.
If a MTX channel is selected, this will adjust the send levels from
AUX1–8 to MTX.
If AUX/MTX buses are stereo-linked, selecting the odd-
numbered AUX/MTX bus will let you adjust the send pan, and
selecting the even-numbered AUX/MTX bus will let you adjust
the send level.
•
SENDS ON FADER button
This button turns SENDS ON FADER mode on/off. It will blink
if SENDS ON FADER mode is on.
“Using the SENDS ON FADER” (p. 43)
5
This control is invalid for the following channels:
• AUX1–8
• MTX1–4
• MAIN L/R/C
6
7
8
M-300_e.book 24 ページ ２０１０年６月２４日 木曜日 午後２時２６分