Filter
Top Products
56
AUX, MTX, MAIN operations
AUX, MTX, MAIN operations
Use the PREAMP area of the CHANNEL EDIT section to adjust the
attenuator.
1.
Use the GAIN dial to adjust the attenuator.
fig.ChEdtPreamp.eps
This operation is performed in the COMP area of the CHANNEL
EDIT section.
fig.ChEdtComp.eps
1.
Press [DISP] of the COMP area to access the LIMITER
popup.
For details, refer to “Limiter operations” (p. 78).
Holding down [SHIFT] and pressing [DISP] for the COMP area
switches the limiter on/off.
This operation is performed in the PAN area of the CHANNEL EDIT
section. This is valid for the MAIN L/R and for stereo-linked AUX/
MTX.
fig.ChEdtPan.eps
1.
Use the PAN knob to adjust the balance.
You can make fine adjustments by holding down [SHIFT] while you
operate the knob.
Use the EQUALIZER area of the CHANNEL EDIT section to operate
the EQ.
fig.ChEdtEQ.eps
1.
In the CHANNEL EDIT section, press [CH DISP].
fig.ScrChAux.eps
The CHANNEL DISPLAY screen will appear.
2.
Press [ON] to turn the 8-band EQ on/off.
3.
User the [HI MID
] / [HI ] to select the band.
4.
Use the GAIN knob to adjust the gain of the selected
band.
5.
Use the FREQ knob to adjust the center frequency of the
selected band.
6.
Use the Q knob to adjust the Q of the selected band.
You can make fine adjustments by holding down [SHIFT] while you
operate the knob.
By pressing [DISP] you can access the 8-BAND EQ popup, where
you can make detailed settings for the 8-band EQ. For details,
refer to “8-band EQ operations (AUX/MTX/MAIN)” (p. 82).
ATT (Attenuator) adjustments
Limiter operations
Adjusting the left/right output balance
8-band EQ operations
M-300_e.book 56 ページ ２０１０年６月２４日 木曜日 午後２時２６分