Filter
Top Products
174
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
1.
Access the desired M-48 SETUP popup.
fig.ScrM48Setup.eps
2.
Press [F6 (PREF)].
fig.ScrM48Pref.eps
The M-48 PREFERENCES popup will appear.
3.
Press [F7 (RESET)].
fig.ScrM48Pref_Conf.eps
A message will ask you to confirm the operation.
4.
Press [F8 (RESET)] to return the preference settings to
their default state.
Pressing [F7 (CANCEL)] will cancel the operation.
The preference settings will be set to the following values:
1.
Access the desired M-48 SETUP popup.
fig.ScrM48Setup.eps
2.
In the GROUP MIX (VOLUME) area, move the cursor to the
desired group name and press [ENTER].
fig.ScrM48GrpName.eps
The NAME EDIT popup will appear.
3.
Use the name edit field to edit the name.
For details on name editing, refer to “Editing a name” (p. 37).
4.
Press [F8 (OK)] to finalize the edited name and close the
popup.
Pressing [F7 (CANCEL)] will cancel the operation and close
the popup.
Returning the preference settings to the
default state
Parameter
Values
SOLO
MODE ADD ON
LAYER select clears SOLO No
MEMORY Disable RECALL button No
Disable STORE button No
LINE OUT SOURCE MAIN BUS
LPF OFF
MONO OFF
Assigning group names for an M-48 unit
M-300_e.book 174 ページ ２０１０年６月２４日 木曜日 午後２時２６分