Filter
Top Products
86
AUX send/MTX send
AUX send/MTX send
The MTX sends are used to send audio signals from AUX1–8 or MAIN L/R/C to MTX1–4.
fig.OutBlkMtxSends.eps
The MTX SENDS popup is used to perform MTX send operations.
MTX send operations
AT T
POST ATT PRE EQ PRE FADER POST FADER OUTPUT POST DELAY
POST DELAY
FX
INSERT
MUTE
FADER
BAL
EXT FX
INSERT
MAIN OUT L
AUX 1–8 OUT
TO SOLO
LIMITER DELAY
AT T
POST ATT PRE EQ PRE FADER
POST FADER
OUTPUT
FX
INSERT
MUTE
FADER
BAL
EXT FX
INSERT
SOLO
TO MONITOR SEL
TO REC SEL
TO FX SOURCE SEL
LIMITER
MAIN L, R, C
AUX 1–8
PRE EQ
PRE FADER
POST FADER
PRE EQ
PRE FADER
POST FADER
TO MONITOR SEL
TO REC SEL
TO MONO MIX
MTX SEND 1–4
TO MTX 1, 3
TO MTX 2, 4
ONSEND
MTX
LINK
PA N
ONSEND
MTX SEND 1–4
TO MTX 1, 3
TO MTX 2, 4
ONSEND
MTX
LINK
PA N
ONSEND
8-BAND
PEQ
8-BAND
PEQ
DELAY
AFL ON
PFL
AFL
GR
GR
1.
In the fader module section, press a [SEL] button to select
the desired channel.
Select from AUX1–8 or MAIN L/R/C.
2.
In the AUX/MTX SENDS area of the CHANNEL EDIT
section, press [DISP].
fig.ScrMatrixSends.eps
The MTX SENDS popup will appear.
●
MTX sends 1–4
These adjust the sends from the AUX or MAIN to MTX. The
MTX send area is structured as follows:
fig.PopMtxSendFieldGuide.eps
Number/Name
This indicates the MTX number and name.
Send level bar
This adjusts the send level to MTX in a range of -Inf dB–+10.0
dB.
The color of the send level bar indicates the send point or
the status of the send switch, as follows:
ON button
This turns the send switch on/off. The send switch turns the
signal to MTX on/off.
Send point select buttons
These select the point from which the AUX or MAIN signal is
sent to MTX, from the following choices:
LINK switch
This turns linking of adjacent odd-numbered/even-
numbered MTX on/off. If this is on, the adjacent MTX will be
linked.
2
1
3 4 5
1
Color of the send
level bar
Status
Blue
PRE EQ or PRE FADER send point
Green POST FADER send point
Gray Send switch is off
PRE EQ Send from the pre-EQ point.
PRE FD Send from the pre-fader point.
POST FD Send from the post-fader point.
2
3
4
5
M-300_e.book 86 ページ ２０１０年６月２４日 木曜日 午後２時２６分