Filter
Top Products
69
Dynamics
Dynamics
fig.PopGateGuide.eps
KEY-IN meter
This indicates the level of the key-in signal. For stereo-linked
channels, two meters are shown (L and R).
IN meter
This indicates the input level to the gate/expander. For
stereo-linked channels, two meters are shown (L and R).
GR (Gain Reduction) meter
This indicates the amount of gain reduction produced by the
gate/expander.
Gate/expander graph
This indicates the approximate response of the gate/
expander.
OUT meter
This indicates the output level of the gate/expander. For
stereo-linked channels, two meters are shown (L and R).
TYPE select button
These select the gate/expander type from the following
choices:
Parameters
In this field you can edit the gate/expander parameters.
The contents of this field will depend on the type you select
in the TYPE select button.
Gate
fig.PopGateGuide2.eps
THRESH knob
This adjusts the threshold level in a range of -80.0 dB–0.0 dB.
RANGE knob
This adjusts the RANGE in a range of -Inf dB–0.0 dB.
ATTACK knob
This adjusts the ATTACK time in a range of 0.0 ms–800.0 ms.
This is the time from when the input signal exceeds the
threshold level until the gate opens completely.
RELEASE knob
This adjusts the RELEASE time in a range of 0 ms–8000 ms.
This is the time over which the gate reaches its maximum
effect after the HOLD time has elapsed.
HOLD knob
This adjusts the HOLD time in a range of 0 ms–8000 ms. This
is the time from when the input signal falls below the
threshold level until the gate begins closing.
When the GATE/EXPANDER popup is displayed, the gate/
expander can be adjusted using the EQUALIZER area controls
for the CHANNEL EDIT section.
Press [HI MID ] / [HI
] to select PARAM1 or PARAM2, and
use Q/FREQ/GAIN knobs to control the corresponding
parameters.
GATE/EXPANDER popup
GATE
EXPANDER
DUCKING
2
1
3
4 5
9
8
6
7
1
2
3
4
5
6
7
Selection
Knob Parameter
PARAM 1
Q Threshold level
FREQ Attack time
GAIN Release time
PARAM 2 Q Range
FREQ -
GAIN Hold time
1 2
3
4
5
1
2
3
4
5
M-300_e.book 69 ページ ２０１０年６月２４日 木曜日 午後２時２６分