Filter
Top Products
202
Appendix
Appendix
fig.AlgoRevwGate.eps
This is a mono-in, stereo-out reverb. It provides a gate that can be
used for gating or ducking, allowing you to cut the reverb during
its decay, or to cut the reverb when the level of the original sound
is high.
Reverb
SIZE (Room size)
Size of the room or hall
Value: 5–40 m
TIME (Reverb time)
Length of the reverberation
Value: 0.1–32.0 s
Pre Dly (Pre-delay time)
Time until the reverb is heard
Value: 0–200 ms
ER Lev (Early reflection level)
Level of the early reflections
Value: -INF–0.0 dB
DIFFUS (Diffusion)
Amount of scattering for the early reflections
Value: 0–100
DENSITY
Density of the reverb sound
Value: 0–100
LO FREQ DAMP GAIN
Low-frequency attenuation of the reverb sound
Value: -36.0–0.0 dB
LO FREQ DAMP FREQ
Frequency at which the low-frequency region of the reverb
sound begins to be attenuated
Value: 20 Hz–2.00 kHz
HI FREQ DAMP GAIN
High-frequency attenuation of the reverb sound
Value: -36.0–0.0 dB
HI FREQ DAMP FREQ
Frequency at which the high-frequency region of the reverb
sound begins to be attenuated
Value: 200 Hz–20.00 kHz
HI CUT FREQ
Frequency at which the high-frequency region of the reverb
sound will be cut
Value: 200 Hz–20.00 kHz
WET (Wet Level)
Level of the reverb sound
Value: -INF–+6.0 dB
DRY (Dry Level)
Level of the original sound
Value: -INF–+6.0 dB
EQ
EQ SW (EQ switch)
Turns the EQ on/off
Value: OFF, ON
EQ ATT (EQ attenuator)
Attenuator for the EQ
Value: -42.0–+6.0 dB
LO GAIN
Gain of the Lo band
Value: -15.0–+15.0 dB
LO FREQ
Center frequency of the Lo band
Value: 20 Hz–20.00 kHz
LO-MID TYPE
Filter type for the Lo-Mid band (*1)
Value: PEAK, LSV, HSV, LPF1, HPF1, LPF2, HPF2,
BPF, BEF, THRU
LO-MID GAIN
Gain of the Lo-Mid band (*1)
Value: -15.0–+15.0 dB
LO-MID FREQ
Center frequency of the Lo-Mid band (*1)
Value: 20 Hz–20.00 kHz
LO-MID Q
Steepness of the frequency response curve at the Lo-Mid band
center frequency (*1)
Value: 0.36–16.00
HI-MID TYPE
Filter type for the Hi-Mid band (*1)
Value: PEAK, LSV, HSV, LPF1, HPF1, LPF2, HPF2,
BPF, BEF, THRU
HI-MID GAIN
Gain of the Hi-Mid band (*1)
Value: -15.0–+15.0 dB
REVERB+GATE
Input L
Input R
Reverb
DRY
DRY
4 Band EQ
Output L
Output R
Key-In
Gate
M-300_e.book 202 ページ ２０１０年６月２４日 木曜日 午後２時２６分