Filter
Top Products
209
Appendix
Appendix
Value: OFF, ON
EFF SW (Effect switch)
Turns the effect sound on/off
Value: OFF, ON
fig.AlgoStPhase.eps
This is a stereo-in, stereo-out phaser. It lets you apply a phaser
effect without impairing the position of the sound image that’s
been set for the stereo input, by panning or other means.
Phaser
RATE
Phaser rate
Value: 0.01–10.0 Hz
DEPTH
Phaser depth
Value: 0–100
MANUAL
Center frequency at which the phaser effect is applied
Value: 0–100
LFO PHASE
Phase difference between L and R for the LFO (Low-Frequency
Oscillator)
Value: -180–180 deg
FB (Feedback)
Amount of phaser sound that is returned to the input of the
phaser
Value: -100–100
XFB (Cross feedback)
Amount of phaser sound that is returned to the opposite-side
input of the phaser
Value: -100–100
LEVEL
Phaser level
Value: 0–100
MODE
Type of phaser
Value: 4STAGE, 8STAGE
DIR SW (Direct switch)
Turns the unprocessed sound on/off
Value: OFF, ON
EFF SW (Effect switch)
Turns the effect sound on/off
Value: OFF, ON
St.PHASER (Stereo Phaser)
Feedback means returning the effect sound back into the
input. The feedback level specifies the amount of sound
that is returned. Cross-feedback is when the effect sound is
returned back to the opposite-side (left or right) input. The
cross-feedback level specifies the amount of sound that is
returned. In modulation-type effects, raising the feedback
value will make the sound richer and more spacious.
Negative values will invert the phase.
Input L
Input R
Phaser L
Output L
Output R
DIR SW
Phaser R
XFB
FB
FB
DIR SW
EFF SW
EFF SW
M-300_e.book 209 ページ ２０１０年６月２４日 木曜日 午後２時２６分