Filter
Top Products
169
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
Specifying the outputs from the M-300 to the M-48 unit
Use the REAC B output patchbay to specify the outputs from the
M-300 to the M-48.
1.
In the SETUP section, press [PATCHBAY] to access the
PATCHBAY screen.
fig.ScrPatchbay1.eps
2.
Press [F2 (OUTPUT)] and [F4 (REAC B)] to view the REAC B
output patchbay.
fig.ScrPatchbay2.eps
3.
Use the patchbay grid to select the channels that will be
output to the M-48.
For example, you might make settings as follows:
By using direct out from the PRE EQ or PRE FADER positions, you
can create a mix in which the M-48’s source level/pan settings are
independent of the M-300.
If you use direct out from the POST FADER position, each source will
be output at the level determined by the M-300’s channel fader. In
this case the actual LEVEL setting of the M-48 source is controlled by
the M-300 fader.
In addition to input channel direct outs, you can use a variety of
outputs as sources for the M-48.
• By patching the AUX, MTX, or MAIN outputs you can use
group mixes or the house mix as a source for the M-48.
• By patching TALKBACK you can establish smooth
communication with the musicians.
These output settings are shared by all REAC devices that are
connected to REAC B.
Example) When the S-1608 and M-48 are connected to REAC B
fig.V-Mix_M48_2.eps
• REAC B OUT 1–8 are output from OUTPUT 1–8 of the S-1608.
• Of the 40 sources the M-48 receives via REAC B OUT, sources
1–8 are the same as OUTPUT 1-8 of the S-1608.
REAC B
Channel Purpose
OUT 1–6
AUX1–6 S-1608 stage outputs
OUT 7–8 MAIN L, MAIN R
OUT 9–40 CH1–CH32 direct out M-48 sources
REAC B
M-300
S-4000D
OUT1–40
Output REAC B OUT1–8Mix REAC B OUT1–40
S-1608M-48
M-300_e.book 169 ページ ２０１０年６月２４日 木曜日 午後２時２６分