Filter
Top Products
184
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
1.
Access the M-48 MEMORY popup.
fig.ScrM48Memory.eps
2.
Select the desired memory in the memory list.
If the ALL UNITS tab is shown, all M-48 units will be affected by
this operation (except for units whose MEMORY SAFE function is
on).
3.
Press [F5 (STORE)].
fig.ScrM48MemStore.eps
The M-48 MEMORY STORE popup will appear.
4.
Edit the name in the name edit field, and press
[F8 (STORE)].
fig.ScrM48MemStore_Conf.eps
A message will ask you to confirm the store operation.
In this example, the current memory is being stored to memory
number 3.
You cannot execute this operation for units whose MEMORY
SAFE function is turned on.
5.
Press [F8 (STORE)].
The M-48’s current memory settings will be stored to the
memory you selected in step 2, and the popup will close.
Pressing [F7 (CANCEL)] will cancel the operation.
1.
Access the M-48 MEMORY popup.
2.
Select the desired memory in the memory list.
If the ALL UNITS tab is shown, all M-48 units will be affected by
this operation (except for units whose MEMORY SAFE function is
turned on).
3.
Press [F4 (RECALL)].
fig.ScrM48MemRecall_Conf.eps
A message will ask you to confirm the recall operation.
In this example, memory number 3 is being recalled.
You cannot execute this operation for units whose MEMORY
SAFE function is turned on.
4.
Press [F8 (RECALL)].
The memory you selected in step 2 will be recalled to the M-
48’s current memory, and the popup will close.
Pressing [F7 (CANCEL)] will cancel the operation.
1.
Access the M-48 MEMORY popup.
2.
Select the desired memory in the memory list.
If the ALL UNITS tab is shown, all M-48 units will be affected by
this operation (except for units whose MEMORY SAFE function is
turned on).
3.
Press [F6 (CLEAR)].
fig.ScrM48MemClr_Conf.eps
A message will ask you to confirm the operation.
In this example, memory number 3 is being cleared.
You cannot execute this operation for units whose MEMORY
SAFE function is turned on.
4.
Press [F8 (CLEAR)].
The contents of the memory you selected in step 2 will be
cleared, and the memory will be initialized.
Pressing [F7 (CANCEL)] will cancel the operation.
Storing the M-48’s current memory
Recalling a memory to the M-48
Clearing the contents of an M-48 memory
M-300_e.book 184 ページ ２０１０年６月２４日 木曜日 午後２時２６分