Filter
Top Products
82
4-band EQ/8-band EQ
4-band EQ/8-band EQ
8-band EQ operations (AUX/MTX/MAIN)
8-band EQ is provided on AUX1–8, MTX1–4, and MAIN L/R/C.
You can select one of the three filter types on band 1 and band 8.
Band 2–7 provide peaking-type filters.
The 8-BAND EQ popup is used to perform 8-band EQ operations.
1.
In the fader module section, press a [SEL] button of the
AUX/MTX/MAIN to select the desired channel.
2.
In the EQUALIZER area of the CHANNEL EDIT section,
press [DISP].
The 8-BAND EQ popup will appear.
fig.Pop_8BandEQGuide.eps
IN meter
This indicates the input level of the 8-band EQ. For stereo-
linked channels, two meters (L and R) are shown.
8-band EQ graph
This indicates the approximate response of the 8-band EQ.
OUT meter
This indicates the output level of the 8-band EQ. For stereo-
linked channels, two meters (L and R) are shown.
8-band EQ parameters
Band 1 type
You can select one of the following filter types:
Band 8 type
You can select one of the following filter types:
Q knob
This adjusts the Q of the peaking-type filters in a range of
0.36–16.00. Higher values produce a sharper curve.
The Q knob is not shown in bands 1/8 when LSV/HSV is selected
as a filter type.
FREQ knobs
This adjusts the center frequency of each band in a range of
20Hz–20.0kHz.
GAIN knobs
This adjusts the gain of each band in a range of -15.0 dB–
+15.0 dB.
The GAIN knob is not shown bands 1/8 when HPF/LPF is
selected as a filter type.
Noise may occur when you operate the filter or 8-band EQ,
but this is not a malfunction.
The function buttons have the following operations:
While holding down the [SHIFT] button, the function buttons
will be changed to [F1 (BAND 1)]–[F8 (BAND 8)]. These allow you
to directly select the target band for the knobs in the
EQUALIZER area of the CHANNEL EDIT section.
Accessing the 8-BAND EQ popup
LSV
Low-shelving
PEAK Peaking
HPF High-pass filter
21 3
4
1
2
3
4
1
2
3
4
5
1
HSV
High-shelving
PEAK Peaking
LPF Low-pass filter
[F2 (EQ ON)] Turns the 8-band EQ on/off.
[F4 (LIBRARY) Accesses the 8-BAND EQ LIBRARY popup (p.
81).
[F5 (PEAK CLEAR)] Clears the level meter’s peak hold or over
indication.
[F6 (FLAT)] Sets the 8-band EQ to flat response (p. 81).
[F8 (CLOSE)] Closes the popup.
2
3
4
5
M-300_e.book 82 ページ ２０１０年６月２４日 木曜日 午後２時２６分