Roland M-300 DJ Equipment User Manual


 
171
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
A unit name of up to eight characters can be assigned to each M-
48. If you’re managing multiple M-48 units, use these names to
quickly distinguish between the units.
With the factory settings, the unit name will be “NO NAME.”
1.
Access the M-48 MANAGER popup.
fig.ScrM48Manager.eps
2.
In the M-48 list, move the cursor to the UNIT NAME of the
desired M-48 and press [ENTER].
fig.ScrM48UnitName.eps
The NAME EDIT popup will appear.
3.
Edit the name in the name field.
For details on name editing, refer to “Editing a name” (p. 37).
If you turn [F6 (BLINK LEDs)] on, all LEDs of the target M-48 will
flash. You can use this to identify a specific unit.
4.
Press [F8 (OK)] to finalize the name and close the popup.
If you press [F7 (CANCEL)], the operation will be cancelled
and the popup will close.
1.
Access the M-48 MANAGER popup.
2.
In the M-48 list, move the cursor to the MUTE field of the
desired M-48 and press [ENTER] to add a check mark.
The PHONES and LINE OUT outputs of the checked M-48
unit(s) will be muted.
If any of the M-48 units in the M-48 list have been muted, the M-
48 MANAGER popup’s [F1 (MUTE CLEAR)] indication will be on.
1.
Access the M-48 MANAGER popup.
2.
In the M-48 list, move the cursor to the NO. field of the
desired M-48 and press [ENTER].
fig.ScrM48Arrange.eps
The ARRANGE UNIT popup will appear.
3.
Use the value dial to specify the desired order for that
M-48 unit.
4.
Press [F8 (OK)].
The M-48 list will be reordered so that the selected M-48 is in
the place you specified in step 3, and the popup will close.
If you press [F7 (CANCEL)], the operation will be cancelled and
the popup will close.
The M-300 will show the connected M-48 units in the M-48 list in
the order in which the units are detected; the displayed order is
remembered so that this order can be reproduced the next time
the power is turned on.
This operation will update the display priority order as well as
the order in the M-48 list.
1.
Access the M-48 MANAGER popup.
2.
In the M-48 list, move the cursor to the MEMORY SAFE
field of the desired M-48 and press [ENTER] to add a
check mark.
M-48 units with a check mark will not accept Store or Recall
operations from the M-300.
When you’re managing multiple M-48 units, this allows you to
prevent unintended memory operations, or to exclude specific
M-48 units when synchronizing scene memories with M-48
memories.
Editing the M-48’s unit name
Muting the output of an M-48 unit
Changing the order of a unit in the M-48 list
Disabling memory operations from the
M-300 (MEMORY SAFE function)
M-300_e.book 171 ページ 2010年6月24日 木曜日 午後2時26分