Filter
Top Products
57
AUX, MTX, MAIN operations
AUX, MTX, MAIN operations
This operation is performed in the AUX/MTX SENDS area of the
CHANNEL EDIT section.
You can adjust the send level in either of two ways: operating on
AUX/MAIN, or operating on MTX.
fig.ChEdtAux.eps
Operating on AUX/MAIN
1.
Press [SEL] of the MAIN or AUX to select the send-source.
2.
Press [MTX1]–[MTX4] to select the send-destination MTX
bus.
3.
Use the SEND LEVEL knob to adjust the amount of signal
sent to the MTX bus.
You can make fine adjustments by holding down [SHIFT] while you
operate the knob.
You can’t use SENDS ON FADER to adjust the send amount to an
MTX bus.
By pressing [DISP] you can access the MTX SENDS popup where
you can make detailed MTX send settings (p. 86).
Operating on MTX
1.
Press [SEL] of the MTX to select the send-destination MTX
bus.
2.
Press [AUX1]–[AUX8] on the AUX/MTX SENDS area to
select the send-source AUX.
3.
Use the SEND LEVEL knob to adjust the amount of signal
sent to the MTX bus.
You can also adjust the send level from the MAIN to the MTX in
the CHANNEL DISPLAY screen of the MTX.
You can make fine adjustments by holding down [SHIFT] while you
operate the knob.
You can’t use SENDS ON FADER to adjust the send amount to an
MTX bus.
Sending to the MTX buses
M-300_e.book 57 ページ ２０１０年６月２４日 木曜日 午後２時２６分