Filter
Top Products
47
Input channel operations
Input channel operations
AUX/MTX SENDS
fig.ScrChSends.eps
Here you can adjust the sends from the channel to the
AUX1–8 or MTX1–4 buses.
●
AUX/MTX sends
The AUX/MTX sends are organized as follows:
fig.ScrChSendField.eps
AUX/MTX number
This indicates the AUX/MTX number.
AUX/MTX name
This indicates the AUX/MTX name.
Send level bar
This adjusts the send level to the AUX/MTX bus in a range of
-Inf dB– +10.0 dB.
The color of the send level bar indicates the send point and
the status of the send switch as follows:
●
AUX/MTX pan slider
fig.ScrChSendField2.eps
If the AUX/MTX send-destination is stereo-linked, this lets
you adjust the left/right panning of the audio signal in a
range of L63–R63. This is shown in the area of the odd-
numbered AUX/MTX send.
For details, refer to “AUX/MTX send operations (CH1–32)” (p. 84).
PAN
fig.ScrChPan.eps
LCR button
This button specifies how signals are sent from the channel
to MAIN L/R and MAIN C.
* The MAIN button appears at the position of LR button and C
button when the LCR button is turned on.
CENTER
This specifies the proportion of the signal that is sent to
MAIN C when PAN is at C (center) as a value in a range of
0%–100%.
This is valid when the LCR button is on.
fig.Pan_LCR.eps
PAN
• When LCR button is off
This adjusts the left/right panning of the audio signal sent to
the MAIN L/R buses in a range of L63–R63.
• When LCR button is on
This adjusts the left/center/right panning of the audio signal
sent to the MAIN L/R/C buses in a range of L63–R63.
Send level bar color Status
Blue send point is PRE EQ or PRE FADER
Green send point is POST FADER
Gray Send switch is off
9
1 2
3
1
2
3
LCR
button
Explanation
OFF
The signals sent to MAIN L/R and MAIN C can be
individually turned on/off by using the LR button and C
button.
ON PAN will operate across the three outputs MAIN L,
MAIN C, and MAIN R. The convergence of the sound to
MAIN C can be adjusted by CENTER. The signals sent to
MAIN L/R and MAIN C can be collectively turned on/off
by the MAIN button.
*
CENTER
Explanation
0%
No signal will be sent to MAIN C.
100% When PAN is set to C, the signal will be sent only to MAIN
C.
10
1
2 3
1
2
LC
PA N
LEVEL
R
t
o
L
E
F
T
t
o
R
I
G
H
T
Center 0%
LC
PA N
LEVEL
R
t
o
L
E
F
T
t
o
R
I
G
H
T
t
o
C
E
N
T
E
R
Center 50%
LC
PA N
LEVEL
R
t
o
L
E
F
T
t
o
R
I
G
H
T
t
o
C
E
N
T
E
R
Center 100%
3
M-300_e.book 47 ページ ２０１０年６月２４日 木曜日 午後２時２６分