Filter
Top Products
32
Basic operation
Basic operation
Basic panel operations
fig.LayerBtn.eps
Use the buttons of the Layer section to select the channel layer
that will be controlled by the fader module section. Each channel
layer assigns the following channels to the fader module section:
Here’s how to edit the channel parameters.
1.
In the fader module section or main fader module, press
a [SEL] button to select the channel that you want to
control.
fig.SELBtn.eps
2.
In the CHANNEL EDIT section, press [CH DISP].
fig.ChDispBtn.eps
3.
The CHANNEL DISPLAY screen will appear. Use the
controllers of the CHANNEL EDIT section to edit the
values.
fig.ScrChDisp.eps
You can make adjustments in finer increments by holding down
[SHIFT] while you operate the CHANNEL EDIT section’s knobs or the
value dial.
If you want to edit channel parameters that are not shown in the
CHANNEL DISPLAY screen, you can press the [DISP] button in each
area of the CHANNEL EDIT section to access a popup that lets you
make settings in greater detail.
If you’ve selected the CHANNEL SELECT item “CHANNEL
DISPLAY follows CH SELECT button” in User Preference (p. 137),
pressing a [SEL] button will cause the CHANNEL DISPLAY screen
of that channel to appear.
Selecting the channel layer
Channel layer
Channels
USER 2
USER LAYER 2
USER 1 USER LAYER 1
AUX/MTX/DCA AUX1–8, MTX1–4, DCA1–4
CH 17-32 CH17–32
CH 1-16 CH1–16
Operations in the CHANNEL EDIT section
[SEL]
[SEL]
[CH DISP]
M-300_e.book 32 ページ ２０１０年６月２４日 木曜日 午後２時２６分