43
Input channel operations
Input channel operations
Use the EQUALIZER area of the CHANNEL EDIT section to operate
the EQ.
fig.ChEdtEQ.eps
1.
Press [ON] to turn the 4-band EQ on/off.
2.
Use the band selection button ([LO]/[LO MID]/[HI MID]/
[HI]) to select the band.
3.
Use the GAIN knob to adjust the gain of the selected
band.
4.
Use the FREQ knob to adjust the center frequency of the
selected band.
5.
Use the Q knob to adjust the Q of the selected band.
You can make fine adjustments by holding down [SHIFT] while you
operate the knob.
By pressing [DISP] you can access the 4-BAND EQ popup, where
you can make detailed settings for the 4-band EQ. For details,
refer to “4-band EQ operations (CH1–32)” (p. 80).
Use the PAN area of the CHANNEL EDIT section to make these
adjustments.
fig.ChEdtPan.eps
1.
Use the PAN knob to adjust the pan.
You can make fine adjustments by holding down [SHIFT] while you
operate the knob.
Use the AUX/MTX SENDS area of the CHANNEL EDIT section to
perform these operations.
fig.ChEdtAux.eps
You can adjust the send level in either of two ways: using the
SEND LEVEL knob of the AUX SENDS area, or using the faders of
the top panel.
Using the SEND LEVEL knob
1.
Press [AUX1]–[AUX8] /[MTX1]–[MTX4] to select the send-
destination AUX/MTX bus.
2.
Use the SEND LEVEL encoder to adjust the amount sent
to the selected AUX/MTX bus.
You can make fine adjustments by holding down [SHIFT] while
you operate SEND LEVEL.
You can turn the corresponding send switch on/off by holding
down [SHIFT] and pressing [AUX1]–[AUX8] / [MTX1]–[MTX4].
Using the SENDS ON FADER
1.
Press [AUX1]–[AUX8] / [MTX1]–[MTX4] to select the send-
destination AUX bus.
2.
Press [SENDS ON FADER] so it is blinking.
3.
Use the top panel faders to adjust the amount sent from
each input channel to the selected AUX/MTX bus.
fig.FaderAll.eps
By pressing [DISP] you can access the AUX/MTX SENDS popup.
For details, refer to “AUX/MTX SENDS popup” (p. 84).
4-band EQ operations
Adjusting the pan
Sending to the AUX/MTX buses
M-300_e.book 43 ページ 2010年6月24日 木曜日 午後2時26分