Filter
Top Products
89
Input/output patchbay
Input/output patchbay
Patchbay operations
You can change the settings of the input/output patchbays. Use
the PATCHBAY screen to perform patchbay operations.
1.
In the SETUP section of the top panel, press [PATCHBAY].
fig.ScrPatchGuide.eps
The PATCHBAY screen will appear.
Current assign indication
For the input patchbay, this indicates the physical input
source that is patched to the input channel at the cursor
location.
For the output patchbay, this indicates the output channel
that is patched to the physical output at the cursor location.
Device indication
This indicates the input/output unit that is connected to the
REAC port currently selected by the function buttons, or
indicates the M-300 itself.
Patchbay grid
This grid lets you make patchbay settings.
fig.ScrPatGridGuide.eps
Channel indication
This indicates the channel number and name.
Jack indication
This indicates the jack number. For the input patchbay, this
also indicates the signal level at the input jack.
The color indicates the signal level as follows:
Patch symbol
A patch symbol is shown where the currently patched
channel and jack intersect. To change the patching, move
the cursor to the location where the desired channel and
jack intersect, and press [ENTER].
Unavailable jack area
The number area is shown in gray for jacks that cannot be
used with the currently connected REAC slave input/output
unit.
The function buttons have the following operations:
Accessing the PATCHBAY screen
21 3
1
2
3
1
2
3
4
1
Color
Level
Black Below -48 dB
Green Between -48 dB and -18 dB
Yellow Between -18 dB and 0 dB
Red Above 0 dB
[F1 (INPUT)] Displays the INPUT tab, where you can set the
input patch bay (p. 90).
[F2 (OUTPUT)] Displays the OUTPUT tab, where you can set
the output patchbay (p. 92).
[F3 (REAC A)] Allows you to make patch bay settings for the
REAC A input/output jacks.
[F4 (REAC B)] Allows you to make patch bay settings for the
REAC B input/output jacks.
[F5 (CONSOLE)] Allows you to make patch bay settings for the
M-300’s rear panel input/output jacks, and for
internal ports such as the effect output and the
USB memory recorder output.
[F6 (LIBRARY) Accesses the INPUT PATCHBAY LIBRARY popup
(p. 90) or OUTPUT PATCHBAY LIBRARY popup
(p. 92).
[F7 (PREAMP EDIT)] Accesses the PREAMP EDIT popup, where you
can set the preamp gain.
2
3
4
M-300_e.book 89 ページ ２０１０年６月２４日 木曜日 午後２時２６分