Filter
Top Products
35
Basic operation
Basic operation
Sub-display area
This area shows supplementary information. The following
information is shown:
●
Indication of the currently edited parameter value
fig.SubDispPrm.eps
When you edit a parameter whose value is not shown in the
screen, or use the controllers of the CHANNEL EDIT section
to edit a parameter, the value is shown here for a short time.
●
Output mute status
fig.SubDispOsc.eps
This indicates that the outputs have been muted by means
of [F6 (MUTE ALL OUT)] in the MUTE GROUP screen (p. 110),
or by means of [MUTE ALL OUTPUTS] on the input/output
unit.
●
Oscillator indication
fig.SubDispOsc.eps
This is shown if the oscillator is on.
●
Recorder status indication
fig.SubDispRcdr.eps
While a song is playing or being recorded, this shows the
song name and time information.
These are popups that are shown overlaid on the main display
area. They provide a cursor and function buttons for performing
operations in the screen.
fig.Popups.eps
While a popup is displayed, cursor and function button
operations are valid only for the popup.
fig.FuncBtnGuide.eps
The function buttons are assigned to the main display area of the
screen or the popup, and are operated using [F1]–[F8]. There are
three types of function buttons, as follows:
●
Command function buttons
fig.FuncBtnCmd.eps
These execute commands or access popups.
●
On/off function buttons
fig.FuncBtnOnOff.eps
These turn parameters or functions on/off. The button in the
screen is shown in gray when off, or light blue when on.
●
Display select tabs
fig.FuncBtnTab.eps
These tabs are used to switch between screens.
fig.Cursor.eps
The cursor is indicated by a red frame in the main display area or
in the popup. Use the up/down/left/right keys to move the
cursor.
4
If you attempt to operate a parameter that has been
disabled by a user setting (p. 133), the following
indication will appear:
Popup Indication
Function button operations
Cursor operations
M-300_e.book 35 ページ ２０１０年６月２４日 木曜日 午後２時２６分