Filter
Top Products
29
Explanation of the panels
Explanation of the panels
fig.ConsInJackGuide.eps
CONSOLE INPUT 1–4
These are balanced XLR-3-31 female input jacks for inputting
analog audio signals from microphones or line level
equipment.
By default they are patched to CH17–20.
922
Wiring diagrams for these jacks are shown below. Make
connections after first checking the wiring diagrams of other
equipment you intend to connect.
fig.XLRJackInput.eps
CONSOLE INPUT 5–8
These are TRS type (balanced) jacks for inputting analog
audio signals from line level equipment.
By default they are patched to CH21–24.
922
Wiring diagrams for these jacks are shown below. Make
connections after first checking the wiring diagrams of other
equipment you intend to connect.
fig.TRSJack.eps
CONSOLE INPUT 9–12
These are RCA phono jacks for inputting analog audio
signals from line level equipment.
By default they are patched to CH25–28.
926a
When connection cables with resistors are used, the volume
level of equipment connected to the inputs (CONSOLE
INPUT) may be low. If this happens, use connection cables
that do not contain resistors.
fig.ConsOutJackGuide.eps
CONSOLE OUTPUT 1–4
These are balanced XLR-3-32 male output jacks for
outputting analog audio signals.
By default, MAIN L/R, MONITOR L/R are patched to them.
922
Wiring diagrams for these jacks are shown below. Make
connections after first checking the wiring diagrams of other
equipment you intend to connect.
fig.XLRJack.eps
CONSOLE OUTPUT 5–8
These are TRS type (balanced) jacks for outputting analog
audio signals.
By default, AUX1–4 are patched to them.
922
Wiring diagrams for these jacks are shown below. Make
connections after first checking the wiring diagrams of other
equipment you intend to connect.
fig.TRSJack.eps
CONSOLE INPUT jacks
1
12
3
1
+PHANTOM[+48V/14mA]
GND
COLD
HOT
2
3
CONSOLE OUTPUT jacks
2
12
1
HOT
COLD
GND
12
2
The CONSOLE INPUT 5–8 jacks and CONSOLE OUTPUT 5–8
jacks can also be used as input/output jacks for inserting
external effect processors into channels. For details, refer to
“Inserting an external effects device” (p. 106).
M-300_e.book 29 ページ ２０１０年６月２４日 木曜日 午後２時２６分