Filter
Top Products
61
AUX, MTX, MAIN operations
AUX, MTX, MAIN operations
PAN
• When LCR button is off
This adjusts the left/right panning of the audio signal sent to
the MAIN L/R buses in a range of L63–R63.
• When LCR button is on
This adjusts the left/center/right panning of the audio signal
sent to the MAIN L/R/C buses in a range of L63–R63.
FROM AUX send / FROM MAIN send (MTX only)
fig.ScrFromAuxSends.eps
These adjust the send levels from the AUX or MAIN to the MTX.
The FROM AUX send /FROM MAIN send are structured as follows:
fig.ScrFromAuxSendField.eps
AUX number/MAIN number
This indicates the AUX number, MAIN L/R or MAIN C.
AUX/MAIN name
This indicates the name of the AUX/MAIN.
Send level bar
This adjusts the send level to the MTX in a range of -Inf dB–
+10.0dB.
The color of the level bar indicates the send point or status of
the send switch as follows:
Balance
fig.ScrChBal.eps
This adjusts the left/right output balance sent from MAIN L/R or
stereo-linked AUX/MTX in a range of L63–R63.
Group
fig.ScrChGroup.eps
By moving the cursor to DCA GROUP or MUTE GROUP and
pressing [ENTER], you can access the GROUP ASSIGN popup
where you can make DCA group and MUTE group assignments.
You can also access the GROUP ASSIGN popup window by
pressing [F5 (GROUP ASSIGN)].
Fader
fig.ScrChFaderOut.eps
Fader
This adjusts the output level in a range of -Inf dB–+10.0 dB.
Channel meter
This indicates the signal level of the channel. For stereo-
linked channels, two meters (L and R) are shown. The point
at which the signal level is detected will be as specified in the
METER screen. For details, refer to “Editing the meter
settings” (p. 96).
S button
This turns SOLO on/off for the channel.
M button
This turns MUTE on/off for the channel.
Color of the send
level bar
Status
Blue send point is PRE EQ or PRE FADER
Green send point is POST FADER
Gray Send switch is off
5
7
1 2
3
1
2
3
8
9
10
1
2
3
4
1
2
3
4
M-300_e.book 61 ページ ２０１０年６月２４日 木曜日 午後２時２６分