Filter
Top Products
176
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
PAN knob
This adjusts the source’s panning in a range of L63–C–R63.
Fader
This adjusts the source’s level in a range of -Inf dB – +10.0 dB.
Group
Shows a group to which a source is assigned.
If a source is not assigned to any groups, that shows "--."
“Source Assign settings” (p. 178)
The function buttons have the following operations:
1.
Access the desired M-48 SETUP popup.
fig.ScrM48Setup.eps
2.
Press [F3 (SOURCE LEV/PAN)].
fig.ScrM48SrcLev1.eps
The M-48 SOURCE LEV/PAN popup will appear.
3.
Verify that the desired M-48 is shown in the target unit
indication.
If the wrong unit is selected, press [F8 (CLOSE)] to close the
popup; then re-select the target and return to step 2.
4.
Use [F1 (SOURCE LAYOUT)] or [F2 (M-300 LAYOUT)] to
select the display that you prefer.
1.
Access the desired M-48 SOURCE LEV/PAN popup.
fig.ScrM48SrcLev1.eps
2.
Move the cursor to the faders and pan knobs of sources
1–40, and use the value dial to edit the values.
3.
If you want to use the M-300’s top panel faders to control
the levels, turn [F5 (SOURCE ON FADER)] on.
The display in the M-300 LAYOUT tab will switch in tandem
with the M-300’s channel layer buttons.
1.
Access the desired M-48 SOURCE LEV/PAN popup.
fig.ScrM48SrcLev1.eps
2.
Press [F7 (RESET)].
fig.ScrM48SrcLevClr_Conf.eps
A message will ask you to confirm the operation.
3.
Press [F8 (RESET)] to reset the source level/pan settings
and close the popup.
The parameters of each source will be set to the following
[F1 (SOURCE LAYOUT)]
Switches to the SOURCE LAYOUT tab.
[F2 (M-300 LAYOUT)] Switches to the M-300 LAYOUT tab.
[F3 (COPY MIX LEVEL)] Accesses the COPY MIX LEVEL popup, where
you can copy the M-300’s mix levels to
sources (p. 177).
[F5 (SOURCE ON FADER)] If this is on, you’ll be able to use the top panel
faders to adjust the source levels.
[F7 (RESET)] Resets the source level/pan settings (p. 176).
[F8 (CLOSE)] Closes the popup.
Accessing the M-48 SOURCE LEV/PAN
popup
4
5
6
Editing the source level/pan settings
Resetting the source level/pan settings
M-300_e.book 176 ページ ２０１０年６月２４日 木曜日 午後２時２６分