Filter
Top Products
59
AUX, MTX, MAIN operations
AUX, MTX, MAIN operations
For details, refer to “Limiter operations” (p. 78).
Insert indication
fig.ScrChInsOut.eps
FX INS
If FX1–FX4 are inserted, the number of the inserted FX is
shown here.
If the number is shown in white, the effect insertion is
enabled. If it is shown in gray, effect insertion is bypassed.
If you move the cursor to FX INS and press [ENTER], the
EFFECTS screen will appear.
Inserting an effect into a channel is done in the EFFECTS screen.
For details, refer to “Inserting an effect into a channel” (p. 101).
Up to four effects can be inserted into one channel. In this case,
they will be inserted in series, in order of the FX number.
EXT FX
If an external effects processor is inserted, this shows the
number of the inserted EXT FX.
By moving the cursor to EXT FX and pressing [ENTER], you
can access the EXTERNAL INSERT screen.
Inserting an external effects processor into a channel is done in
the EXTERNAL INSERT screen. For details, refer to “Inserting an
EXT FX into a channel” (p. 107).
8-band EQ
fig.ScrChEQ.eps
EQ button
This turns the 8-band EQ on/off.
OL (Overload) indicator
This will light when the output of the 8-band EQ exceeds the
OVER Lev setting specified in the METER SETUP popup (p.
96).
8-band EQ graph
This shows the approximate response of the 8-band EQ.
Band 1 type
You can select on of the following filter types:
Band 8 type
You can select one of the following filter types:
Q
This adjusts the Q in a range of 0.36–16.00. Higher values
produce a sharper curve.
FREQ
This adjusts the center frequency in a range of 20Hz–
20.0kHz.
GAIN
This adjusts the gain in a range of -15.0dB–+15.0dB.
For details, refer to “8-band EQ operations (AUX/MTX/MAIN)” (p.
82).
3
1
2
1
2
4
1 2
3
4 5
6
7
8
LSV
low-shelving
PEAK peaking
HPF high-pass filter
HSV high-shelving
PEAK peaking
LPF low-pass filter
1
2
3
4
5
6
7
8
M-300_e.book 59 ページ ２０１０年６月２４日 木曜日 午後２時２６分