Filter
Top Products
178
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
Source Assign settings
This assigns source 1 through 40 to group 1 through 16 for
operating the M-48 panel. You make assignments to the groups
using the M-48 SOURCE ASSIGN popup.
1.
Access the desired M-48 SETUP popup.
fig.ScrM48Setup.eps
2.
Press [F4 (SOURCE ASSIGN)].
ffig.ScrM48SrcAsgn_Guide.eps
The M-48 SOURCE ASSIGN popup will appear.
Target M-48 indication
This indicates the unit name of the M-48 that is the target of
the M-48 SOURCE ASSIGN popup.
Current assign indication
This indicates the group to which the source at the cursor
location is assigned.
Assignment grid
This grid lets you assign sources to groups (knob 1–16).
fig.ScrM48AsgnGrid_Guide.eps
Source indication
This indicates the number and name of each source.
Group indication
This indicates the number and name of each group (knob).
Assignment symbol
This symbol is shown at the intersection of each currently
assigned source and group.
To change an assignment, move the cursor to the location
where the desired source and group intersect, and press
[ENTER].
A source can be assigned only to one group. You cannot assign
the same source to multiple groups.
Sources that are not assigned to a group cannot be controlled
from the M-48’s panel. If you don’t want these sources to be
output from the M-48, use the source level/pan settings (p. 175)
to set their level to -Inf dB.
The function buttons have the following operations:
Accessing the M-48 SOURCE ASSIGN
popup
2
1
3
1
2
3
2
3
1
[F1 (LAYER 1-8)]
Displays groups 1–8.
[F2 (LAYER 9-16)] Displays groups 9–16.
[F7 (CLEAR ALL)] Clears the source assignment settings (p. 179).
[F8 (CLOSE)] Closes the popup.
1
2
3
In some cases you may want to set a source level up even
though it is not assigned to a group (knob) for a particular M-
48.
1. For talkback communication
The mixing engineer can have talkback as one of the 40
sources, leaving the source level up but not assigned to
a particular group (knob). This way the talkback signal is
not controlled by any of the M-48 knobs yet still can be
heard by the musician.
2. To provide simple control
E.g., The mixing engineer can provide just vocal control
for a vocalist via source assignment. All other sources
are not assigned to any groups (knobs) and can be
provided as a fixed mix. The vocalist just adjusts the
volume of their voice alone.
M-300_e.book 178 ページ ２０１０年６月２４日 木曜日 午後２時２６分