Filter
Top Products
Quick Tour
ZOOM HD8/HD16
33
6. While playing the song, turn the parameter
knob to adjust the send level value for each
track.
7. Adjust the intensity of the other send/return
effect in the same way.
8. To return to the main screen, press the [EXIT]
key.
You can apply the insert effect to the output of any track, so
that it post-processes the output signal of the track.
1. While the main screen is displayed, press the
[INPUT SOURCE] key in the control section.
2. Turn the dial to bring up the track to which
you want to apply the insert effect on the
second line of the display.
The status key of the selected track lights up in orange.
If the drum track is selected, the [RHYTHM] status key is lit
in green. If the bass track is selected, the key is lit in red.
HINT
The insert position can also be selected with the status keys.
To select a mono track x 2, hold down one status key while
pressing the other one.
3. Press the [EXIT] key to return to the main
screen.
4. While the main screen is displayed, hold
down the [SHIFT] key in the pad section and
press pad 4 (INSERT EFFECT).
While you hold down the [SHIFT] key, pad 4 (INSERT
EFFECT) is lit. The display indication changes as follows, and
the second line shows the currently selected patch.
NOTE
If pad 4 (INSERT EFFECT) does not light although the [SHIFT]
key is pressed, the insert effect is set to the bypass (off)
condition (“Off” is shown on the first line of the display). Press
the pad again to light it.
5. Use the cursor up/down keys to select the
algorithm for the insert effect.
<< only>> With the HD16, the number and combination
of tracks for insertion changes as follows. If necessary, repeat
steps 1 – 3 to select the insert target tracks again.
• When 8x COMP EQ algorithm is selected
You can select eight continuous tracks (Track 1 – 8 or Track
9 – 16) as insert location. Also if you have selected track 9
– 16, you can set different high-pass filter/compressor/EQ
values for odd/even-numbered tracks.
• When an algorithm other than 8x COMP EQ is
selected
You can select one of eight mono tracks (Track 1 – Track 8)
or two mono tracks/one stereo track (Track 1/2 – Track 15/
16) as insert location.
6. While playing the song, turn the dial to select
the patch.
The insert effect can now be used to post-process the specified
track. When the effect is applied, the track output level may
change. Use the respective fader to readjust the level as
necessary.
HINT
<< only>> When the 8x COMP EQ algorithm is selected,
settings and effect on/off switching can be done individually for
each channel (
→ p. 128).
7. When you have checked the effect, stop the
song and press the [EXIT] key to return to the
main screen.
HINT
If the insert effect is applied to the track output, it is not
possible to also apply it to the input or before the [MASTER]
fader. However, by using the bounce function (
→ p. 44) to
record the track/V-take on another empty V-take, you can turn
the post-processed effect sound into audio data and then
apply the insert effect at another position.
4.4 Applying the insert effect
to a track
Changing the algorithm/insert location of
the insert effect
Input Source
Input Source
Input
Input
Input Source
Input Source
Track3
Track3
CLEAN
CLEAN
No.0:Standard
No.0:Standard