Filter
Top Products
170
When “LFO Wave” is set to Random, the “Step” parameter uses a
random LFO cycle.
b: LFO Phase
Offsetting the left and right phases alters how modulation is
applied to the left and right channels, creating a swelling affect.
f: BPM, g: StepBase, g: Times
The width of an LFO step, or a cycle of random LFO, is obtained
by multiplying the length of a note (…) (selected for “Step-
Base”, in relation to the tempo specified in “BPM,” or the MIDI
Clock tempo if “BPM” is set to MIDI) by the number specified in
the “Times” parameter.
j: W/D
The effect sound’s phase will be reversed when you set this
parameter in the range of values from –Wet to –1:99.
11: St.Exct/Enhcr
(Stereo Exciter/Enhancer)
This effect is a combination of the Exciter, which adds a punch
to the sound and the Enhancer, which adds spread and pres-
ence.
a: Blend
This parameter sets the depth (intensity) of the Exciter effect. Pos-
itive values give a frequency pattern (to be emphasized) different
from negative values.
b: Point
This parameter sets the frequency to be emphasized. Higher val-
ues will emphasize lower frequencies.
c: Enh Dly L, d: Enh Dly R
These parameters set the delay time for the Enhancer left and
right channel. Specifying a slightly different delay time for the left
and right channel will add a stereo image, depth, and width to the
sound.
12: St.Sub OSC
(Stereo Sub Oscillator)
This effect adds very low frequencies to the input signal. It is
very useful when simulating a roaring drum sound or
emphasizing powerful low range. This effect is different from
the equalizer in that you can add very low range harmonics.
You can also adjust the oscillator frequency to match a partic-
ular note number, for use as an octaver.
a
Blend (Exciter Blend)
Sets the intensity (depth) of the Exciter effect
–100...+100
☞,
(Source) Off...Tempo
Selects the modulation source of the Exciter intensity
(Amount) –100...+100
Sets the modulation amount of the Exciter intensity
b
Point (Emphatic Point)
Sets the frequency to be emphasized
0...70
☞,
(Source) Off...Tempo
Selects the modulation source of the frequency to be emphasized
(Amount) –70...+70
Sets the amount of modulation of the frequency to be emphasized
c
Enh Dly L (Enhancer Delay L)
Sets the delay time for the Enhancer left channel
0.0...50.0ms
☞
d
Enh Dly R (Enhancer Delay R) [msec] 0.0...50.0ms
Sets the delay time for the Enhancer right channel ☞
Random Filter LFO
LFO Step Freq
LFO Frequency
LFO Step Freq
Step-Tri
Random
LFO Phase
0 +90
+180 [degree]
0 [degree]
–90
–180
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
EQ Trim
LEQ HEQ
EQ Trim
Delay
Delay
Depth
D
-mod
Exciter
Exciter
Enhancer
e
Enh Dep (Enhancer Depth) 0...100
Sets the determines to what degree the Enhancer effect is applied
(Source) Off...Tempo
Selects the modulation source of the Enhancer width
(Amount) –100...+100
Sets the modulation amount of the Enhancer width
f
Pre EQ Trim
Sets the EQ input level
0...100
g
LoEQ (Pre Low EQ Gain)
Sets the gain of Low EQ
–15.0...+15.0dB
HiEQ (Pre High EQ Gain)
Sets the gain of High EQ
–15.0...+15.0dB
h
W/D (Wet/Dly) Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
(Source) Off...Tempo
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
–100...+100
a
OSC Mode Note (Key Follow), Fixed
Determines whether the oscillator frequency follows the note number
or whether it is fixed
☞
b
Note Interval –48...0
Sets the pitch difference from the note number when OSC
Mode=Note (Key Follow)
☞
c
Fine (Note Fine)
Fine adjustment of the oscillator frequency
–100...+100
☞
d
Fixed (Fixed Frequency) 10.0...80.0Hz
Sets the oscillator frequency when OSC Mode=Fixed
(Source) Off...Tempo
Selects the modulation source for the oscillator frequency when OSC
Mode=Fixed
(Amount) –80...+80Hz
Sets the oscillator frequency modulation amount when OSC
Mode=Fixed
Stereo In - Stereo Out
D
-mod
Envelope Sens
Envelope Shape
Response
Wet / Dry
Wah
Sweep Mode
D-mod
Auto
Left
Right
Wet / Dry
LFO
LFO
Wah
+