Filter
Top Products
Effect
181
31: Scratch
This effect is applied by recording the input signal and mov-
ing the modulation source. It simulates the sound of scratches
you can make using a turntable.
a: Scratch Source, b: Response(Scratch)
The Scratch Source parameter enables you to select the modula-
tion source that controls simulation. The value of the modulation
source corresponds to the playback position. The
Response(Scratch) parameter enables you to set the speed of the
response to the modulation source.
c: Envelope, c:Src, d: Threshold
When “Envelope” is set to Dmod, the input signal will be
recorded only when the modulation source value is 64 or higher.
When “Envelope” is set to Input, the input signal will be recorded
only when its level is over the Threshold value.
The maximum recording time is 1365msec. If this is exceeded, the
recorded data will start being erased from the top.
e: Response(Env)
This parameter enables you to set the speed of the response to the
end of recording. Set a smaller value when you are recording a
phrase or rhythm pattern, and set a higher value if you are record-
ing only one note.
f: Direct Mix
With Always On, a dry sound is usually output. With Always
Off, dry sounds are not output. With Cross Fade, a dry sound is
usually output, and it is muted only when scratching.
Set W/D to Wet to use this parameter effectively.
a
Scratch Source Off...Tempo
Selects the modulation source for simulation control ☞,
b
Response(Scratch) 0...100
Sets the speed of the response to the Scratch Source ☞
c
Envelope (Envelope Select) Dmod, Input
Selects whether the start and end of recording is controlled via the
modulation source or the input signal level
☞,
Src (Source) Off...Tempo
Selects the modulation source that controls recording when Enve-
lope is set to Dmod
☞
d
Threshold 0...100
Sets the recording start level when Envelope is set to Input ☞
e
Response(Env) 0...100
Sets the speed of the response to the end of recording ☞
f
Direct Mix Always On, Always Off, Cross Fade
Selects how a dry sound is mixed ☞
g
W/D (Wet/Dly) Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
(Source) Off...Tempo
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
–100...+100
Input
D-mod
Envelope Select
D
-mod
Envelope Control
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Scratch
Direct
Mix
D
-mod
Rec Control
Scratch
+ Max
Zero
Scratch!
D
-mod
– Max
JS X
Rbn#16
JS+Y#1
JS–Y#2
etc…
Zero
+ Max
Scratch Source
Recorded Sound
Scratch Source
Start Playback Position End