Filter
Top Products
81
SEQ
1.1
1.22.12.23.13.23.33.44.14.24.34.45.15.26.17.17.2
Set Song Length
This command changes the length of the specified song.
When it is executed, the length of the master track will
change, and the number of measures played will change.
1 Select “Set Song Length” to access the dialog box.
2 In “Length,” specify the length of the song.
3 To execute the Set Song Length command, press the [F8]
(“OK”) key. To cancel without executing, press the [F7]
(“Cancel”) key.
Be aware that if you shorten the song, data will also be
deleted from the tracks other than the master track.
Here you can specify how the arpeggiator will operate in
Sequencer mode. These settings can be made for each song.
In Sequencer mode (as in Combination mode), you can run
the two arpeggiators simultaneously. This allows you to
apply different arpeggio patterns to different sounds that
have been split across the keyboard, or use velocity to
switch between two different arpeggio patterns, etc.
In Sequencer mode, the musical data generated by the
arpeggiator during song track or pattern realtime-recording
can be recorded. While you record, you can modify the
arpeggio pattern and parameters, and adjust the REALTIME
CONTROLS C-mode [ARP-GATE] knob and [ARP-VELOC-
ITY] knob etc.
It is not possible to set the tempo of the arpeggiator and
the sequencer independently.
When “MIDI Clock” (GLOBAL 2.1–1a) is Internal, the
arpeggiator can be synchronized to the start timing of the
internal sequencer.
•When you turn on the arpeggiator and press the
[START/STOP] key, the arpeggiator will synchronize to
the timing of the sequencer.
•When you press the [START/STOP] key, the arpeggiator
and sequencer will both stop. If you wish to stop only
the arpeggiator, press the [ARP ON/OFF] key.
When the arpeggiator “Key Sync” is off, you can turn on the
[ARP ON/OFF] key and play the keyboard to start the
arpeggiator running during the pre-count before realtime
recording begins, so that the arpeggiator performance will
be recorded from the beginning of the pattern at the same
time that recording begins. (
☞BG p.107)
When “MIDI Clock” is External, the MIDI realtime
clock messages transmitted from the external MIDI
device connected to MIDI IN connector can perform the
same type of control.
Even in this case, you can start/stop using the [START/
STOP] key of the TRITON Le’s sequencer.
6.1–1: Set..8 (Setup T01–08)
6.1–2: Set..16 (Setup T09–16)
6.1–1(2)a: Arpeggiator Run, (Tempo)
Arpeggiator Run A, B (Run A, B)
When the [ARP ON/OFF] key is on, the arpeggiator(s) that
are checked here will function for the track(s) to which they
are assigned by “Assign.” When the arpeggiator is on, A and
B can be turned on/off independently.
(Tempo) [040...240, (EXT)]
Specify the tempo of the arpeggiator. Refer to “ (Tempo)”
(
☞1.1–1a).
SEQ 6.1: Arp. (Arpeggiator)
6.1–1a
6.1–1b
1.1–1c
6.1–1c