Filter
Top Products
4.55 System Parameter Settings
4.5.5.6.2 Dialing Parameters
Parameter
Number of Digit
to Access
Outside Line
Call Transfer
No-answer Time
Outgoing Call
No-answer Time
Pause Time
System Administration Top Menu + 1 + 5 + 6 + 2
Program - System Parameter - Others - Dialing Parameter Menu
Number of Digits to Access Outside Line (O-8 digits) - : 1
Call Transfer No-answer Time (1 O-60 set)----- : 20
Outgoing Call No-answer Time (1 O-90 set) -- : 30
Pause Time ---
--__
---- :
2
Outgoing Call Setup Sequence
- : T . . . . . . . . . .
Value Range
(default)
O-8 digits
(1)
lo-60 set
(20)
lo-90 set
(30)
l-9 set
(2)
Description/Function
Specifies the number of digits required to access
an outside line.
Example:
If the PBX requires callers to dial ‘9’ in order to
access an outside line, this parameter should be
set to 1 digit. This caudes the system to be
aware that, when dialing the number 9-123-4567
for example, outgoing call setup sequence is done
after the initial ‘9’ is dialed. The full sequence is
therefore: 9- [outgoing call setup sequence] -123
-4567.
For periodic port usage reports, the VPS can
discriminate between local and long distance calls
and can report outgoing calls and calling times
for billing purpose.
Specifies the amount of time that the VPS should
wait before receiving the transferred call if there
is no answer at the destination extension.
Specifies the’amount of time that the VPS should
wait before concluding that the outgoing call will
not be answered.
Specifies the pause duration which is used at the
time of entering telephone numbers in the VPS.
It is a pause time between dialed dig&.
Reference
Outgoing
Call Setup
Sequence
p.4-66
Port Usage
Report.
p.7-18
Call Transfe
Status
p.3- IO
E.M.D.
Service
p.3-22
M.W.N.-
Device
p.3-38
System Administrator
4-65