Filter
Top Products
4.5.5 System Parameter Settings
Parameter
Value Range
(default)
Description/Function Reference
Outgoing Call
Ports
Port No. Specifies the port numbers used for the Message
Number to
(1, 2, 3. 4)
Waiting Notification-Device feature. The VPS
Dial
makes outgoing calls using a port specified in this
p.4-23
field. At least one port must be specified.
[Note]
The value range depends upon the models.
TVS75 -Port 1,2
TVS 100 - Port l-4
Message
Waiting Lamp
Ports
Port No.
Specifies the port numbers used for the Message
M.W.N.-
(1, 2, 3, 4) ’
Waiting Notification-Lamp feature.
Lamp
The VPS turns on the message waiting lamp of
p.3-41
the extension using a port specified in this field.
At least one port must be specified.
[Note]
The value range depends upon the models.
TVS75 -Port1,2
TVS 100 - Port l-4
Message
Waiting Lamp
for Every
Message
1. Yes
2. No
(W
If set to “Yes”, the ,VPS will turn on the message
waiting lamp of the extension every time a new
message is recorded in the mailbox even if the
message waiting lamp has not been turned off
from a previous message.
If set to “No”, the VPS will turn on the message
waiting lamp for only the first message. It will
not notify subsequent messages until the
Subscriber has accessed the VPS to receive the
message.
This setting is useful if the first attempt has
unsuccessful for some reason.
Max. Digits for
Callback No.
1-48 digits
Specifies the maximum number of digits the
Callback
cm
caller can enter as a callback number. This
Number
number will be displayed on beepers if “Beeper
Entry
p.3-7
Callback No.
Entry Interdigit
Time-Out
l-10 set
(5)
Callback No. Entry Mode” is activated.
Number to
Dial
Sets the maximum time allowed between each
p.4-23
digit on Beeper Callback No. Entry. If the caller
Type
does not enter any digits within this length of
~A-24
time following the last digit entry, the VPS
Beeper
considers it as the end of entry and do.es not
Callback Nc
accept additional entry.
Entry Mode
p.4-33
System Administrator
4-67