Filter
Top Products
4.5.6 Hkdware Settings
4.5.6.3.2 Inband Signaling Parameters
These parameters are used if the PBX sends DTMF tones to the VPS to indicate
the state of a call (busy, answered, disconnected, etc.). The Integration mode on
page 4-8 1 must be set to “Inband”. If PBX Type is set to a KX-T series telephone
system. the Inband Signaling parameters will automatically default to the proper
codes.
System Administration Top Menu + 1 + 6 -+ 3 + 2
Program - Hardware - PBX Interface - lnband Signaling Menu
Ringback---------------
Busy-----
______ ---------
Reorder __---_-- ____ -_ ____ -__---
D N D ---_---____ ___------- -----
Answer _-________- _______-- -
Forward to VM Ringing-----
-
Forward to VM Busy ~----
Forward to Other Extension ---
---
Confirmation ----------
___-------
Disconnect -___ ___I_---- ------
: 1..
: 2..
: 3..
: 4..
: 5..
: 6..
: 7..
: 8..
: 9..
: a...
.
. . .
. . .
. . .
. . .
. . .
. . .
. . . . .
. .
0, 1, 2, 3, 4, 5, 6, 7, 8, 9, X, #, A, B, C, D
Parameter
Value Range
(default)
Description/Function * Reference
The following parameters can be programmed using “O-9”, “xc”, ‘%“, and “A-D”.
Ringback
Busy
Reorder
DND
(1)
(2)
(3).
(4)
Indicates “Ringback Tone”. Sent to the VPS when
PBX Type
the extension it dialed is ringing.
p.4-79
Indicates “Busy Tone”. Sent to the VPS when the
extension it dialed is busy.
Integration
Mode
p.4-8 I
Indicates “Reorder Tone”. Sent to the VPS if it
dials an invalid extension number or if it is
inadvertently connected to another VPS.
Indicates “Do Not Disturb Tone”. Sent to the
VPS if the dialed extension has set Do Not
Disturb feature.
System Administrator 4-83