Filter
Top Products
104
Creating a Performance
Volume (Receive Volume Switch)
For each MIDI channel, specify whether MIDI Volume messages will
be received (ON), or not (OFF). Assigning a check mark (✔) will turn
it on, and removing the check mark will turn it off.
Pan (Receive Pan Switch)
For each MIDI channel, specify whether MIDI Pan messages will be
received (ON), or not (OFF). Assigning a check mark (✔) will turn it
on, and removing the check mark will turn it off.
Expression (Receive Expression Switch)
For each MIDI channel, specify whether MIDI Expression messages
will be received (ON), or not (OFF). Assigning a check mark (✔) will
turn it on, and removing the check mark will turn it off.
Hold-1 (Receive Hold 1 Switch)
For each MIDI channel, specify whether MIDI Hold 1 messages will
be received (ON), or not (OFF). Assigning a check mark (✔) will turn
it on, and removing the check mark will turn it off.
Phase Lock (Phase Lock Switch)
Set Phase Lock to “✔” (ON) when you want to suppress
discrepancies in timing of parts played on the same MIDI channel.
When the Phase Lock parameter is set to “ON,” parts on the
same MIDI channel are put in a condition in which their timing
is matched, enabling them to be played at the same time.
Accordingly, a certain amount of time may elapse between
reception of the Note messages and playing of the sounds. Turn
this setting to “ON” only as needed.
Velocity Curve
Velocity Curve selects for each MIDI channel one of the four
following Velocity Curve types that best matches the touch of the
connected MIDI keyboard.
Value: 1–4
fig.Curve-4
Setting Effects for a Performance
(Effects/MFX/MFX Control/Chorus/
Reverb)
For details regarding effect settings, refer to the pages shown
below.
• “Applying Effects in Performance Mode or Multitimbre
Mode” (p. 170)
• “Making Multi-Effects Settings (MFX/MFX Control)” (p. 174)
• “Making Chorus Settings (Chorus)” (p. 176)
• “Making Reverb Settings (Reverb)” (p. 177)
Scale Tune Settings (Scale Tune)
fig.06-14_50
For details on the setting, refer to “How to Make the
Performance Settings” (p. 91).
C–B (Part Scale Tune C–B)
Make scale tune settings for each part.
Value: -64– +63
Scale Tune is switched on/off by means of the Scale Tune Switch
parameter (SYSTEM/Scale Tune) (p. 186).
2134