Filter
Top Products
182
Settings Common to All Modes (System Function)
MTC Offset Frame (MTC Offset Time Frame)
Coordinates the playback timing of the Fantom and the external
device in a frame units.
Value: 00–29 frames
MTC Error Level
Determines how often the reception status is checked when MTC is
being received from an external device. Stop synchronization if a
problem becomes apparent with the check.
Value: 0–10 (the checking interval will be longer for larger values)
In strict terms, the lower the numerical value set, the more
accurate the check is. However, playback may be stopped overly
frequently if too rigorous a check is made, and this soon becomes
inconvenient. By raising the Error Level setting, then even if
problems with the reception of MTC do occur, synchronization
can then continue as long as such problems remain at a level that
does not cause undue problems.
Metronome Mode
Specifies when you want the metronome to sound.
Value
OFF: Will not sound.
PLAY ONLY: Will sound only during playback.
REC ONLY: Metronome will sound only for recording.
PLAY&REC: Metronome will sound for playback and recording.
ALWAYS: Metronome will always sound.
Metronome Level
You can adjust the volume of the metronome.
Value: 0–10
Metronome Sound
Selects the metronome sound.
Value
TYPE 1: A conventional metronome sound will be heard. A bell will
sound on the first beat.
TYPE 2: Clicks will sound.
TYPE 3: Beeps will sound.
TYPE 4: Cowbell will sound for the first beat, and woodblock on
other beats.
MIDI Settings (MIDI)
fig.15-05_50
For details on the setting, refer to “How to Make the System
Function Settings” (p. 178).
MIDI
Performance Ctrl Ch (Performance Control
Channel)
Performance Ctrl Ch selects the MIDI receive channel used during
switching of performances when MIDI messages (Program Change/
Bank Select) are sent from an external MIDI device. Set this to “OFF”
if performances are not to be switched from an external MIDI device.
Value: 1–16, OFF
If only a program change is received, and if the Performance Ctrl
Ch parameter setting coincides with the MIDI receive channel of
a part, priority will be given to switching the performance.
Multitimbre Ctrl Ch (Multitimbre Control
Channel)
Multitimbre Ctrl Ch selects the MIDI receive channel used during
switching of Multitinbres when MIDI messages (Program Change/
Bank Select) are sent from an external MIDI device. Set this to “OFF”
if Multitinbres are not to be switched from an external MIDI device.
Value: 1–16, OFF
If only a program change is received, and if the Multitimbre Ctrl
Ch parameter setting coincides with the MIDI receive channel of
a part, priority will be given to switching the multitimbre.
Patch/Rhythm Rx Ch (Patch/Rhythm Set
Receive Channel)
Specifies the receive channel of MIDI messages in Patch mode.
Value: 1–16