Filter
Top Products
194
Transmitting Sound Settings/Reset to Default Factory Settings
Transmitting Sound Settings
(Data Transfer)
Sound generator settings and system settings stored in the Fantom’s
internal memory or on a Wave Expansion Board can be transmitted
to an external MIDI device, or to user memory.
Transmitting Data to an External
MIDI Device
Patch, rhythm set, multitimbre, performance, and setup and system
settings will be transmitted to an external MIDI device. This
operation is called bulk dump. Use this operation when you want to
connect another Fantom and play it using the same settings, or to
save your data on an external MIDI device as a precaution against
possible loss of sound data or system settings.
To transmit data to an external MIDI device, connect the external
MIDI device and Fantom as shown in the diagram.
fig.17-01.e
1. Press [MENU] to open the Menu window.
2. Press or to select “Data Transfer,” and then press
[8 (Select)].
The Data Transfer window appears.
3. Move the cursor to “Destination” and select “MIDI.”
fig.17-02.e
4. Move the cursor to “Source” and use the following choices
to specify the data that will be transmitted.
*1 Only the current multitimbre/performance settings will be transmitted.
*2 The current multitimbre/performance settings and the setting of a
patch or rhythm set assigned to the part will be transmitted.
Type of Data to Transmit
ALL: Patch, rhythm set, multitimbre, and performance
SETUP: Setup
SYSTEM: System
PATCH: Patch
RHYTHM: Rhythm set
MULTITIMBRE: Multitimbre
PERFORMANCE: Performance
Transmit Source Data
USER: Data from user memory will be transmitted.
TEMP: Transmit the data from the temporary area.
CTRL: The state of the multitimbre/performance (e.g., the
multitimbre/performance bank select and program changes) will be
transmitted as MIDI channel messages, not as exclusive messages.
Refer to “MIDI Implementation” (Sound/Parameter list) for
more on the Control Change messages that are received.
5. Set the external MIDI device so that it will be ready to receive
data, and press [8 (Execute)] to execute data transmission.
While the data is being transmitted, the display will indicate
“Processing...” When “Complete !” is displayed, the
transmission has been completed.
To halt during transmission, press [EXIT].
MIDI OUT
MIDI IN
MIDI Sequencer
Fantom
Type of data to transmit Transmit destination
Transmit source data
Type of data to transmit Transmit source data
ALL USER —
TEMP —
SETUP — —
SYSTEM — —
PATCH USER 001–128
TEMP
RHYTHM USER 001–016
TEMP —
MULTITIMBRE USER 01–16
TEMP -PATCH *1
TEMP +PATCH *2
CTRL —
PERFORMANCE USER 01–64
TEMP -PATCH *1
TEMP +PATCH *2
CTRL —