Filter
Top Products
77
Creating a Rhythm Set
Creating a Rhythm Set
BEND UP: Raises the pitch in semitone steps (up to 4 octaves
higher).
BEND DOWN: Lowers the pitch in semitone steps (up to 4 octaves
lower).
AFTERTOUCH: Aftertouch
NOTE: Play the sound of the most recently pressed key.
OCT UP: Raises the key range in octave steps (up to 3 octaves
higher).
OCT DOWN: Lowers the key range in octave steps (up to 3 octaves
lower).
START/STOP: Starts/Stops the sequencer.
TAP TEMPO: Tap tempo (a tempo specified by the interval at which
you move your hand over the D Beam controller).
PTN SWITCH: Switch Rhythm pattern playback on/off.
PTN ACCENT: Rhythm Pattern Accent Rate
PTN SHFFLE: Rhythm Pattern Shuffle Rate
Polarity (D Beam Polarity)
Switch the polarity of the D Beam controller.
With a setting of “REVERSE,” the direction of control for the D Beam
controller will be inverted.
Range: STANDARD, REVERSE
Range Lower (D Beam Range Lower)
Specify the lower limit of the range of the D Beam controller. Values
below this setting will not be output.
Value: 0–UPPER
Range Upper (D Beam Range Upper)
Specify the upper limit of the range of the D Beam controller. Values
above this setting will not be output.
Value: LOWER–127
Setting Effects for a Rhythm Set
(Effects/MFX/MFX Control/Chorus/
Reverb)
For details regarding effect settings, refer to the pages shown
below.
• “Applying Effects in Patch Mode” (p. 165)
• “Making Multi-Effects Settings (MFX/MFX Control)” (p. 174)
• “Making Chorus Settings (Chorus)” (p. 176)
• “Making Reverb Settings (Reverb)” (p. 177)
Changing How a Rhythm Tone Is
Sounded (WMT)
fig.04-12_50
For details on the setting, refer to “How to Make the Rhythm
Set Settings” (p. 69).
With rhythm tones, sounds are created by combining up to four
Waves (eight for stereo).
WMT
Wave Group
Select the groups containing the Waves comprising the rhythm tone.
Value
INT: Waveforms stored in internal memory
XP-A: Waveform stored in a Wave Expansion Board (SR-JV80 series)
installed in EXP-A slots.
XP-B: Waveforms residing on a Wave Expansion Board (SRX series)
installed in the EXP B slot
XP-C: Waveforms residing on a Wave Expansion Board (SRX series)
installed in the EXP C slot
You cannot select a waveform group of a Wave Expansion Board
that is not installed.
Tips on Creating a Rhythm Tone
The Waves for the bass drum, snare, hi-hat, toms, and other
percussion instruments are each assigned to one rhythm tone.
When adding 3D effects to the sound, make the Pan settings for
each rhythm tone individually.