Filter
Top Products
99
Creating a Performance
Creating a Performance
Ext Bank Select LSB (External Bank Select LSB)
If you want a Bank Select number LSB (controller number 32) to also
be transmitted when you switch performances, specify the value that
you want to transmit (0–127) for each zone.
Value: 0–127
The data of the zone for which the External Switch is turned off
will not be transmitted.
Ext Program Number (External Program
Change Number)
If you want a Program Change number to also be transmitted when
you switch performances, specify the value that you want to
transmit (0–127) for each zone. If you do not want this message to be
transmitted, set this to “---.”
Value: 1–128, ---
The data of the zone for which the External Switch is turned off
will not be transmitted.
Ext Level (External Level)
If you want Volume messages to also be transmitted when you select
a performance, specify the desired value (0–127) for the zone. If you
do not want this message to be transmitted, set this to “---.”
Value: 0–127, ---
The data of the zone for which the External Switch is turned off
will not be transmitted.
Ext Pan (External Pan)
If you want Pan messages to also be transmitted when you select a
performance, specify the desired value (L64–0–63R) for the zone. If
you do not want this message to be transmitted, set this to “---.”
Value: L64–0–63R, ---
The data of the zone for which the External Switch is turned off
will not be transmitted.
Key Range Lower (Keyboard Range Lower)
Specifies the lowest note that the tone will sound for each zone.
Value: C-1–UPPER
Key Range Upper (Keyboard Range Upper)
Specifies the highest note that the tone will sound for each zone.
Value: LOWER–G9
When the Key Range (p. 59) is set for each individual tone in a
patch, sounds are produced in the range where the Key Range of
each tone and the Key Range for the zone overlap.
fig.05-10.e
If you attempt to raise the lower key higher than the upper key,
or to lower the upper key below the lower key, the other value
will be automatically modified to the same setting.
Control Bender (Control Pitch Bend Switch)
For each zone, specify whether MIDI Pitch Bend messages will be
transmitted (ON), or not (OFF).
Value: OFF, ON
Control Aftertouch (Control Aftertouch Switch)
For each zone, specify whether MIDI Aftertouch messages will be
transmitted (ON), or not (OFF).
Value: OFF, ON
Control Modulation (Control Modulation
Switch)
For each zone, specify whether MIDI Modulation messages will be
transmitted (ON), or not (OFF).
Value: OFF, ON
Control Hold Pedal (Control Hold Pedal Switch)
For each zone, you can specify whether control messages from a
pedal connected to the HOLD PEDAL jacks will be transmitted
(ON), or not (OFF).
Value: OFF, ON
Control Pedal 1, 2 (Control Pedal 1, 2 Switch)
For each zone, you can specify whether control messages from a
pedal connected to the CTL 1 and CTL 2 PEDAL jacks will be
transmitted (ON), or not (OFF).
Value: OFF, ON
Key range specified for Performance
Key range specified for Patch
The range in which notes will play