Filter
Top Products
144
Editing Songs
→ Track (Destination Track)
Check/modify the copy-destination track or pattern.
Value
ALL: Phrase tracks 1–16, the beat track, and the tempo track
TRK 1–TRK 16: The specified phrase track
TEMPO: Tempo track
PTN001–PTN100: The specified pattern
• If you set the source track to “ALL,” the destination track can be
set to either “ALL” or “PTN001–PTN100.” If you select
“PTN001–PTN100,” the data from the 16 phrase tracks will be
merged as it is copied.
• If “TEMPO” is selected as the source track, then only “Tempo”
can be selected for the destination track.
→ Measure (Destination Measure)
Check/modify the copy-destination measure.
If you want the copy destination to be right after the last measure of
a song, set this parameter to “END.”
Mode (Copy Mode)
Specifies whether you want to preserve the existing data in the copy
destination when copying.
Value
MIX: Combines the data from the copy source with the existing data
in the copy destination.
REPLACE: Musical data in the copy destination will be erased (i.e.,
overwritten) when the copy takes place. Only the sequencer data of
the MIDI channels specified by the Channel parameter will be
overwritten, and data of other MIDI channels will remain.
Times (Copy times)
Specifies the number of times that the data will be copied to the copy
destination.
Status
Selects the type of data to be copied.
Value
ALL: All types of sequencer data
NOTE: Note
P.AFT: Polyphonic Aftertouch
C.C: Controller numbers
PROG: Program numbers
C.AFT: Channel Aftertouch
BEND: Pitch Bend
EXC: System Exclusive messages
Tune: Tune Request
PTN: Pattern Call Message data
If the source track is set to “TEMPO,” the Status parameter will
not be available.
Range
If you have selected “NOTE,” “P.AFT,” “C.C,” or “PROG” for the
Status parameter, specify the range. Specify the minimum value of
the range at the left, and the maximum value at the right.
• To copy all Note or Polyphonic Aftertouch data, specify “C-1–
G9.” To copy C4 Note/Polyphonic Aftertouch data, specify “C4–
C4.”
• If you want to copy all controller numbers, set this to “0–127.” If
you want to copy all program numbers, set this to “1–128.” To
copy number 4, set “4–4.” To copy numbers from 3 to 14, specify
“3–14.”
Channel (MIDI Channel)
Selects the MIDI channel of the data to be copied.
When you want to copy all the sequencer data, set this parameter to
“ALL.” To copy only the sequencer data of a specific MIDI channel,
select the MIDI channel.
Value: ALL, 1–16
If you set the source track to “TEMPO,” or if the Status
parameter is set to “EXC,” “TUNE” or “PTN,” the Channel
parameter will not be available.
8. When you have finished making settings, press [8 (Execute)]
to execute the operation.