Filter
Top Products
76
Creating a Rhythm Set
Realtime Controller / D Beam
Controller Settings (Controller)
fig.04-11_50
For details on the setting, refer to “How to Make the Rhythm
Set Settings” (p. 69).
Knob
Assign 1–4 (Realtime Control Knob Assign 1–4)
Specify the functions that will be controlled by the [ ]–[ ] knobs.
Value
OFF: The realtime control knob will not be used.
CC01–31, 33–95: Controller numbers 1–31, 33–95
For more information about Control Change messages, please
refer to “MIDI Implementation” (Sound/Parameter List).
PITCH BEND: Pitch Bend
AFTERTOUCH: Aftertouch
TEMPO: Tempo
PTN ACCENT: Rhythm Pattern Accent Rate
PTN SHFFLE: Rhythm Pattern Shuffle Rate
Switch
Assign 1–4 (Realtime Control Button Assign 1–
4)
Specify the functions that will be controlled by the [ ]–[]
buttons.
Value
OFF: The realtime control button will not be used.
CC01–31, 33–95: Controller numbers 1–31, 33–95
For more information about Control Change messages, please
refer to “MIDI Implementation” (Sound/Parameter List).
BEND UP: Raises the pitch in semitone steps (up to 4 octaves
higher).
BEND DOWN: Lowers the pitch in semitone steps (up to 4 octaves
lower).
AFTERTOUCH: Aftertouch
OCT UP: Raises the key range in octave steps (up to 3 octaves
higher).
OCT DOWN: Lowers the key range in octave steps (up to 3 octaves
lower).
TRNS UP: Raises the key range in semitone steps (up to 6 semitones
higher).
TRNS DOWN: Lowers the key range in semitone steps (up to 5
semitones lower).
TAP TEMPO: Tap tempo (a tempo specified by the interval at which
you press the button).
PTN HOLD: Switch between Hold On/Hold Off for the Rhythm
pattern playback.
Mode 1–4 (Realtime Control Button Mode 1–4)
Specify how the [ ]–[ ] buttons are to operate.
Value
MOMENTARY: The button will be on only while you are pressing
(holding) it, and will be off when you release your finger from the
button.
LATCH: The button will switch on/off each time you press it.
D Beam
Switch (D Beam Switch)
Switches the D Beam controller on/off.
Value: OFF, ON
Assign (D Beam Assign)
Specifies the function controlled by the D Beam controller.
Value
OFF: The D Beam controller will not be used.
CC01–31, 33–95: Controller numbers 1–31, 33–95
For more information about Control Change messages, please
refer to “MIDI Implementation” (Sound/Parameter List).