Filter
Top Products
Additional Functions of the Fantom and
Changes in Operation
Linked settings for Loop mode
See pp. 139, 125, 130 in the Owner’s Manual
In the Loop window, you can now select the loop modes
(POINT, 1 MEAS, 2 MEAS, 4 MEAS, 8 MEAS, 16 MEAS,
SONG ALL).
The new Loop window
The selection here is linked with both Loop Play and Loop
Recording. In other words, the settings you make in the Loop
window will be applied to the Loop settings for playback, as
well as to the loop settings for recording in the Recording
Standby window.
Loop on/off settings are also linked between the various
PATCH PLAY, PERFORMANCE PLAY, and MULTITIMBRE
PLAY screens, and in the Loop, Song Edit, and Recording
Standby windows.
Category name display in the
MULTITIMBRE PLAY screen
See pp. 106, 34 in the Owner’s Manual
If the Patch List window or the Rhythm List window are set
to display sorted by categories (i.e., when [7 (Ctg)] has a
check mark (✔) assigned), the category name for the selected
patch will be displayed in the MULTITIMBRE PLAY screen.
fig.03
Undo and Redo in the
MULTITIMBRE PLAY screen
See p. 109 in the Owner’s Manual
After editing Patch or Volume settings in the MULTITIMBRE
PLAY screen, you can revert to the original value (Undo), or
set the edited value again (Redo).
To revert to the original value, hold down [JUMP] and press
[INC] or [DEC]. To set the edited value again, hold down
[JUMP] again and press [INC] or [DEC].
Copy between performances and
multitimbres
See pp. 92, 113 in the Owner’s Manual
In the Performance Copy window and Multitimbre Copy
window, an “All” setting has been added to Mode. When
you use this mode, all name, effect, and part settings can be
copied between performances and multitimbres.
New type added to performance
and multitimbre initialize
See pp. 91, 112 in the Owner’s Manual
In the Performance Initialize window and Multitimbre
Initialize window, a new “SOUND CONTROL” selection has
been added to the Type field. This lets you set the following
parameters for the specified part (Part: All, 1–16) to the
stored value (Value: STORED) or the factory-set value
(Value: DEFAULT).
Cutoff Offset Resonance Offset
Attack Time Offset Release Time Offset
Decay Time Offset Vibrato Rate
Vibrato Depth Vibrato Delay
fig.04
Quantize all tracks at the same
time
See p. 140 in the Owner’s Manual
In the Track Edit (Quantize) window, you can now select
“All” for Track (target track).
This allows you to simultaneously perform quantization on
all tracks: phrase tracks 1–16, beat track, and tempo track.