Filter
Top Products
142
Editing Songs
Erasing Unwanted Performance
Data (Erase)
This function erases all the sequencer data inside the specified area.
As the erased data is replaced by rests, the original measures will
remain.
1. Access the Song Edit screen, and then load the song you
want to edit (p. 136).
2. Press [8 (Track Edit)].
The Track Edit window appears.
3. Press or to select “Erase,” and then press [8
(Select)].
A message of “ERASE: Select target point.” will be displayed.
4. Use [CURSOR] to move the cursor to the first measure of the
track or pattern that you want to erase. To specify all tracks,
press [7 (TrkAll)].
5. Hold down [SHIFT] and press to move the cursor to the
last measure of the track or pattern that you want to erase,
and press [8 (Select)] to specify it.
The Track Edit (Erase) window appears.
fig.11-15_50
6. Use [CURSOR] to move the cursor to the desired parameter,
and turn the VALUE dial or press [INC]/[DEC] to make the
setting. First check the region that is to be affected by the
editing operation, and make corrections if you want to
change it.
Track
Check/modify the track(s) or pattern that is to be erased.
Value
ALL: Phrase tracks 1–16, the beat track, and the tempo track
TRK 1–TRK 16: The specified phrase track
TEMPO: Tempo track
PTN001–PTN100: The specified pattern
Measure, for (Edit Range)
Check/modify the range of measures that are to be erased. If you set
“for” to “ALL,” all measures will be specified.
Status
Selects the type of data to be erased.
Value
ALL: All types of sequencer data
NOTE: Note
P.AFT: Polyphonic Aftertouch
C.C: Controller numbers
PROG: Program numbers
C.AFT: Channel Aftertouch
BEND: Pitch Bend
EXC: System Exclusive messages
Tune: Tune Request
PTN: Pattern Call Message data
If the Track parameter is set to “TEMPO,” the Status parameter
will not be available.
Range
If you have set the Status parameter to “NOTE,” “P.AFT,” “C.C,” or
“PROG,” specify the range. Set the minimum value of the range at
the left, and the maximum value at the right.
• To erase all Note or Polyphonic Aftertouch data, specify “C-1–
G9.” To erase C4 Note/Polyphonic Aftertouch data, specify
“C4–C4.”
• If you wish to delete all controller numbers, select “0–127.” If
you wish to delete all program numbers, select “1–128.” To erase
number 4, specify “4–4.” To erase numbers from 3 to 14, specify
“3–14.”
Channel (MIDI Channel)
Selects the MIDI channel of the data to be erased.
When you want to erase all sequencer data, set this parameter to
“ALL.” To erase sequencer data of one specific MIDI channel only,
select that MIDI channel.
Value: ALL, 1–16
If you set the Track parameter to “TEMPO,” or if the Status
parameter is set to “EXC,” “TUNE” or “PTN,” the Channel
parameter will not be available.
7. When you have finished making settings, press [8 (Execute)]
to execute the operation.