Filter
Top Products
123
Playing Back a Song
Playing Back a Song
5. Use or to specify the songs in the chain, in the
desired order of playback.
• By holding down [SHIFT] and pressing or you can
jump to the beginning or end of the song list.
• By pressing [6 (Select All)] you can add all songs on the disk to
the chain.
• To add sounds (data files) to the chain, press [4 (Sound)], and
make your selection in the Select Sound window that appears.
6. When you are finished selecting songs for the chain, press
[EXIT] to close the Select Song File window.
• If a chain already exists in internal memory, you can insert
additional songs at the cursor location (the current step).
• By holding down [SHIFT] and pressing or you can
jump to the first or last step.
7. Next, specify how the songs registered in the chain are to
begin playing (Play Mode). In the chain, move the cursor to
the song whose Play Mode you want to set, and press [7
(Play/Wait)] to switch the setting.
PLAY: The song will begin playing automatically.
WAIT: The song will begin playing when you press [STOP/
PLAY].
Saving a Chain to Disk (Save)
Any chain you create can be saved to disk as a Chain file.
1. Into the disk drive, insert the disk on which you want to save
the chain file.
2. Access the Chain Play screen (p. 122).
3. Press [2 (Save)].
The Save Chain File window appears.
fig.09-03_50
4. Assign a file name (up to 8 characters). Press [5 (Name)],
and in the Name window that appears, assign the desired file
name.
For details on assigning a name, refer to “Assigning a Name”
(p. 30).
If you want to see a list of the chain files saved on the disk, press
[6 (List)]. If you want to select one of these file names, move the
cursor to the desired chain name, and press [8 (Select)].
5. Press [8 (Execute)] to save the file.
The chain file will be given a filename extension of “.SVC”.
• If you assign a file name that is the same as the name of a file
already existing on the disk, and attempt to perform a save, a
message of “File “****” Already Exists! Over Write OK?” will
appear. If it is OK to overwrite the existing file, press [7 (OK)]. To
cancel the Save operation, press [8 (Cancel)].
• If you attempt to save data on a disk that has not been formatted
by the Fantom, a message of “Unformatted Disk” will appear.
Please format the disk on the Fantom (p. 191).