Filter
Top Products
93
Creating a Performance
Creating a Performance
Saving Performance You’ve
Created (Write)
Changes you make to sound settings are temporary, and will be lost
if you turn off the power or select another sound. If you want to keep
the modified sound, you must save it in the internal USER group
(user memory)
When you modify the settings of a performance, the
PERFORMANCE PLAY screen will indicate “EDITED.” Once you
save the performance into internal memory (user memory), the
“EDITED” indication goes away.
When you perform the save procedure, the data that previously
occupied the save destination will be lost. However, the factory
setting data can be recovered by performing the Initialization
procedure (p. 91).
1. Make sure that performance you wish to save is selected.
2. Press [MENU].
The Menu window appears.
fig.06-01_50
3. Press or to select “Performance Edit,” and then
press [8 (Select)].
The Performance Edit screen appears.
fig.06-02_50
4. Press [6 (Write)].
The Performance Write window appears.
fig.06-07.e
5. Press or to specify the save-destination
performance.
6. Press [8 (Execute)].
The display will indicate “Are you sure?”
7. Press [8 (OK)] to execute the save operation. To cancel the
operation, press [EXIT].
When Changing the Settings for the
Patch or Rhythm Set Assigned to a
Part in a Performance
After changing the settings for the patch or rhythm set assigned to a
part in a performance, if you then try to save the performance
without first saving the changes in the settings, the following
message appears.
fig.06-08_50
If you do not need to keep the patch or rhythm set settings, press [8
(Execute)] to save the performance.
If you want to keep the patch or rhythm set settings, press [7 (Write
Part)] to access the Performance Part Write window.
fig.06-09_50
An indication of “EDITED” will appear for the part for which the
assigned patch or rhythm set was edited. If you want to edit the
patch or rhythm set settings for more than one part, press [3 (▲)] or
[4 (▼)] to select the part.
Specify the save-destination patch and press [8 (Execute)]. The patch
or rhythm set will be saved; then you’ll be returned to the
Performance Write window, where you need to save the
performance once again.
Registering a Favorite Performance
(Favorite Sound)
You can bring together your favorite and most frequently used
performances in one place by registering them in the Favorite sound.
By using this function you can rapidly select favorite performances
from internal memory or a Wave Expansion Board. You can register
a total of 64 sounds (8 sounds x 8 banks) as favorite sounds.
For details on selecting a favorite sound, refer to “Selecting
Favorite Performances (Favorite Sound)” (p. 86).
Save-destination performance