Filter
Top Products
■
Saving a Drum Set you created (User Drum)
You can modify drum instrument parameters to your liking, and save this data as a
Drum Set. A Drum Set saved in this way is called a User Drum Set. You can save up to
two Drum Sets, and since each set contains 128 instrumental sounds, this provides a
total of 256 instrumental sounds (Drum Instruments). You can also give each User Drum
Set a name of your choice. User Drum Sets are stored in Drum Set numbers 65 and 66
of the Native map / SC-88 map (p.104).
* The same contents are stored in both the SC-88 and Native maps.
● Naming a User Drum Set
1. Make sure that the [ALL] indicator is dark.
If it is lit, press [ALL] to turn it off.
2. Use PART [
ll
ll
] [
rr
rr
] to select a Drum Part, simultaneously press PAN [rr
rr
]
and CHORUS [rr
rr
].
The character at the cursor location will blink.
3. U
se PART [ll
ll
] [rr
rr
] to move the cursor where you wish to input a character.
The blinking area will move.
4. Use INSTRUMENT [ll
ll
] [rr
rr
] to select the desired character.
Then repeat from step 3.
Each time you press [ALL], the character will change A → a → A → a.
Pressing [MUTE] will enter a space.
Pressing [SC-55 MAP] will select 0.
Each time you press [SC-88 MAP], the symbol will change & → ( → & → (.
If you wish to change the User Drum Set number, simultaneously press both INSTRU-
MENT [l] and[r] buttons, and then use INSTRUMENT [l] [r] to select the number.
However, be aware that if you change the number, the parameter settings will also
change.
5. Simultaneously press PAN
[rr
rr
]
and CHORUS
[rr
rr
]
to end the procedure.
* To store the name of the User Drum Set in memory, follow the steps explained in “Storing an
entire Drum Set (procedure 2)” on p.103, 105.
PART
INSTRUMENT
SET
100 0
LEVEL
PAN
065*ˇSER DRUM1
PART
INSTRUMENT
SET
100 0
LEVEL
PAN
066*ˇSER DRUM2
INSTRUMENTPAR T
LEVEL
PA N
REVERB
CHORUS
KEY SHIFT
MIDI CH
DELAY
ALL
MUTE
SC
-
55
MAP
SC
-
88
MAP
1
2
3
4
5
Chapter 5. Convenient functions
102