■ System parameter settings
This section explains how to make settings for parameters that affect this entire unit.
These parameters are called System parameters.
System parameters are as follows.
Prevw Note (Preview Note Name)
Prevw Velo (Preview Velocity)
Display (Display Types)
Peak Hold (Peak Hold)
LCD Contrast (LCD Contrast)
Backup (Backup Switch)
IN B Sel. (IN B Select)
OUT/THRU (OUT/THRU Select)
In Mode (Input Mode)
Rx Sys. Mode (System Mode Set receive switch)
Sys.OUT Mode (System Output Mode)
Assign Lock (Output Assign Lock)
P.Load Init (Patch Load Initialize switch)
● Procedure
1. Simultaneously press [uu
uu
] and [dd
dd
].
2. Press either [uu
uu
] or [dd
dd
] to select the parameter you wish to set.
*“
%
” indicates a parameter that affects this entire unit (a System parameter).
3. Use the INSTRUMENT [ll
ll
] [rr
rr
] buttons to set the value.
4. When you finish making settings, simultaneously press the [uu
uu
] and [dd
dd
]
buttons to exit the procedure.
