Filter
Top Products
MOTIF XS Owner’s Manual
Editing a Normal Voice
109
Voice mode
Song mode
Pattern mode
Mixing mode
Master mode
Utility mode
File mode
Performance
mode
Sampling
mode 1
Sampling
mode 2
Reference
From these displays, you can set the Effect related
parameters when the INSERTION CONNECT parameter
(2) is set to “parallel” or “ins A F B” or “ins B F A.”
n Depending on the selected parameter, the LIST icon is shown
at the tab menu corresponding to the [SF6] button. In this
condition, you can call up the list by pressing the [SF6] LIST
button, then select the desired item from the list. For details,
see page 82.
1 Category
2 Type
From the Category column, you can select one of the Effect
Categories each of which contains similar Effect types.
From the Type column, you can select one of the Effect
Types listed in the selected Category.
Settings: Details about the Effect categories and types are described
on page 70.
n The Category (1) is not shown in the Reverb display.
3 Preset
You can set various parameters in order to change how the
sound is affected by the selected Effect type. This
parameter lets you call up the preprogrammed settings of
these effect parameters.
4 Effect Parameters
The number of parameters and values available differs
depending on the currently selected effect type. Refer to
page 73 for details about the Effect parameters. Refer to
the separate Data List booklet for information on the
parameters for each Effect type.
From this display, you can set the Vocoder related parameters. This display called up via the [SF2] button is available only
when the INSERTION CONNECT parameter (2) is set to “ins L” in the Connect display (page 107). Vocoder is a distinctive,
“robot voice” effect which extracts the characteristic of the microphone sound and adds it to the sound via your keyboard
performance. To create this Vocoder effect, you play the keyboard and sing or speak into the microphone at the same time.
To use the Vocoder effect, connect a microphone to the A/D INPUT connector on the rear panel, then follow the instructions
on page 111.
*1 The noise generated in the Vocoder unit is used.
*2 The cutoff frequency of the BPF1’ may not be same as the one of the BPF1. This depends on the settings of the Formant Shift and Formant Offset.
Effect Parameter settings—[SF2] Ins A,
[SF3] Ins B, [SF4] Reverb, [SF5] Chorus
1
2
3
4
Effect Parameter Settings—[SF2] Ins L (Insertion Large)
HPF
Band 10
Band 9
Band 2
Band 1
Noise
Gate
Microphone Input
Noise Input (*1)
Inst Input
(Keyboard Performance)
Extracting the tonal
characteristic
BPF1’
(*2)
Level
detection
BPF1
Volume
control
Output
BPF1
Gain
Dry
Wet