Filter
Top Products
MOTIF XS Owner’s Manual
293
Appendix
Installing Optional Hardware
Available devices
The following optional devices can be installed to the
MOTIF XS.
Installation locations
mLAN16E2
DIMM
Installation Precautions
Before installing the optional hardware, make sure you
have a Philips screwdriver and ample space to work.
• Before beginning installation, switch off the power to the
instrument and connected peripherals, and unplug them from
the power outlet. Installation or removal of any devices should
be started ONLY after the instrument (and the optional
hardware) returns to normal room temperature. Then remove all
cables connecting the instrument to other devices. (Leaving the
power cord connected while working can result in electric
shock. Leaving other cables connected can interfere with work.)
• Be careful not to drop any screws inside the instrument during
installation. (This can be prevented by keeping the optional
units and cover away from the instrument while attaching). If this
does happen, be sure to remove the screw(s) from inside the
unit before turning the power on. Loose screws inside the
instrument can cause improper operation or serious damage. If
you are unable to retrieve a dropped screw, consult your
Yamaha dealer for advice.
• Install the optional units carefully as described in the procedure
below. Improper installation can cause shorts which may result
in irreparable damage and pose a fire hazard.
• Do not disassemble, modify, or apply excessive force to board
areas and connectors on optional units. Bending or tampering
with boards and connectors may lead to electric shock, fire, or
equipment failures.
• It is recommended that you wear gloves to protect your hands
from metallic projections on optional units and other
components. Touching leads or connectors with bare hands
may cause finger cuts, and may also result in poor electrical
contact or electrostatic damage.
• Be careful of static electricity. Static electricity discharge can
damage the IC chips on the mLAN16E2. Before you handle the
optional mLAN16E2, to reduce the possibility of static electricity,
touch unpainted metal parts or a ground wire on the devices
that are grounded.
• Handle the optical units with care. Dropping or subjecting them
to any kind of shock may cause damage or result in a
malfunction.
• Do not touch the exposed metal parts in the circuit board.
Touching these parts may result in a faulty contact.
• Be careful not to misplace any of the screws.
• Do not use any screws other than what are installed on the
instrument. Use of incorrect screws can cause damage.
mLAN16E2
DIMMs
POWER
ON/OFF
AC IN
THRU
MIDI
OUT
IN
PHONESPHONES
ASSIGNABLE
SUSTAIN
FOOT SWITCH FOOT CONTROLLER
21
ASSIGNABLE OUTPUT OUTPUT
RRL L/MONO
DIGITAL OUT
A/D INPUT
R
L
GAIN
LCD CONTRASTETHERNET
USB
TO DEVICETO HOST
MOTIF XS6
MOTIF XS7
Rear cover for the mLAN16E2
Rear cover for the mLAN16E2
MOTIF XS6
MOTIF XS7
MOTIF XS8
Bottom cover for the DIMM
Bottom cover for the DIMM
Bottom cover for the DIMM
WARNING
CAUTION