Filter
Top Products
Start Guide
Resetting the User Memory to the Initial Factory Settings
MOTIF XS Owner’s Manual
22
1 Press the [FILE] button and [UTILITY] button
simultaneously.
The Demo Load display appears.
2 Make sure that the Load Type is set to “all,”
then press the [ENTER] button to load the
Demo data.
A display prompt appears to confirm whether or not the
destination data (Song/Pattern) should be deleted.
n If you want to load only the Demo Song data, set the Load
Type to “song.” If you want to load only the Demo Pattern
data, set the Load Type to “pattern.”
3 Press the [INC/YES] button to execute the
Demo Load operation.
The Demo data is loaded to the Song and Pattern
memory location, then the Song Play Track View display
appears.
n If you set the Load Type to “pattern” in step 2 above, the
Pattern Play display (page 210) appears after loading.
n For more information about the Track View display of the Song,
see page 181. For more information about the Pattern Play
display, see page 210.
FILE UTILITY
DEC/NO
INC/YES
EXIT
EXECUTE
ENTER
Resetting the User Memory to
the Initial Factory Settings
The original factory settings of this synthesizer’s User
Memory can be restored as follows.
n When connecting a computer to the MOTIF-RACK XS
via a IEEE1394 cable, disable the driver used for this
connection beforehand, and follow the procedure below
to execute Factory Set.
When the factory settings are restored, all the Voice,
Performance, Song, Pattern, and system settings in the
Utility mode you created will be erased. Make sure you are
not overwriting any important data. Be sure to save all
important data to your USB storage device or a computer on
the network before executing this procedure (page 278).
1 Press the [UTILITY] button then the [JOB]
button to call up the Factory Set display
(page 269).
2 Press the [ENTER] button.
The display prompts you for confirmation. Press
the [DEC/NO] button to cancel the Load operation.
3 Press the [INC/YES] button to execute the
Factory Set.
After the Factory Set has been completed, a
“Completed” message appears and operation
returns to the original display.
For Factory Set operations that take longer to process, you
will see the message “Now executing Factory Set…” during
processing. While such a message is shown on the display,
never attempt to turn off the power while data is being
written to Flash ROM. Turning the power off in this state
results in loss of all user data and may cause the system to
freeze (due to corruption of data in the Flash ROM). This
means that this synthesizer may not be able to start up
properly, even when turning the power on next time.
When entering the checkmark to the box of the Power On
Auto Factory Set and executing the Factory Set, the Factory
Set will automatically be executed each time turning the
power on. Keep in mind that this also means that your
original data in Flash ROM will be erased each time you turn
on the power. Therefore, the checkmark of this box should
normally be removed. If you remove the checkmark of this
box and execute the Factory Set, the Factory Set will not be
executed when turning the power on next time.
CAUTION
CAUTION
CAUTION