Filter
Top Products
Song Job
MOTIF XS Owner’s Manual
203
Voice mode
Song mode
Pattern mode
Mixing mode
Master mode
Utility mode
File mode
Performance
mode
Sampling
mode 1
Sampling
mode 2
Reference
This Job lets you change the values of specified data such
as Pitch Bend and Control Change in the specified range.
Data changes are calculated as follows:
Modified value = (original value x Rate) + Offset.
Any result lower than the minimum is set to the minimum;
any result higher than the maximum is set to the maximum.
1 Track and range
Determines the Song track (01 – 16, tempo, all) and range
(Measure : Beat : Clock) over which the Job is applied.
2 Event Type
Determines the event type to be modified.
Settings:
When the Track is set to one of 01 – 16 and all:
Pitch Bend, CC & Ch. Mode (Control Change and Channel Mode
Message)*, Ch. After Touch (Channel Aftertouch), Poly After Touch
(Polyphonic Aftertouch)
*You can also specify the Control Number (0 – 127, all)
When the Track is set to “tempo”:
Tempo Change
3 Set All
Sets all target events to the same fixed value. When set to
“off” the Set All parameter has no effect. When set to a
value other than “off,” the Rate and Offset parameters are
unavailable and cannot be set.
Settings: off, 000 – 127 (off, -8192 - +8191 when the Event Type is set
to “Pitch Bend” and off, 5.0 – 300.0 when the Event Type is
set to “Tempo Change.”)
4 Rate
Determines the percentage by which the target events will
be shifted from their original values. When the Set All
parameter (above) is set to other than “off,” this parameter
cannot be set.
Settings: 000% – 200%
5 Offset
Adds a fixed value to the Rate-adjusted event values.
When the Set All parameter (above) is set to other than
“off,” this parameter cannot be set.
Settings: -127 – +127 (-8192 – +8191 for pitch bend)
This Job performs time-expansion or compression over the
selected range.
1 Track and range
Determines the Song track (01 – 16, tempo, all) and range
(Measure : Beat : Clock) over which the Job is applied.
2 Rate
Determines the amount of time expansion or compression
as a percentage. Settings higher than 100% produce
expansion, and settings below 100% produce
compression. A setting of 100 produces no change.
Settings: 025% – 400%
n Only the end point of the range will be shifted forward or
backward by executing the Beat Stretch Job. The data outside
the specified range will be maintained. When expanding the
data, the converted data may overlap the data outside the
range. When compressing the data, an interval of silence will
be created between the end of the compressed data and the
start of the next data outside the range.
[F4] Measure Jobs
This Job creates empty measures at the specified location
in all tracks. When empty measures are inserted, measure
and meter data following the insert point are moved
forward accordingly. If the insert point is set after the last
measure containing data, only the meter data at that point
is set without actually inserting any measures.
07: Modify Control Data
1
2
3
4
5
08: Beat Stretch
01: Create Measure
1
2
1
2
3