Filter
Top Products
Editing a Performance
MOTIF XS Owner’s Manual
145
Voice mode
Song mode
Pattern mode
Mixing mode
Master mode
Utility mode
File mode
Performance
mode
Sampling
mode 1
Sampling
mode 2
Reference
From this display, you can set the control functions for the
Knobs, and the up/down range for the Pitch Bend wheel.
1 Knob Control Assign
Determines which lamp among the TONE 1, TONE 2, ARP
FX, REVERB, CHORUS and PAN is turned on when
selecting a Performance. This setting can be stored for
each Performance.
Settings: tone1, tone2, ARP FX, reverb, chorus, pan
2 Assign 1 Value
3 Assign 2 Value
Indicates the level of the Knobs printed “ASSIGN1” and
“ASSIGN2” at the time at which the Performance is
selected with the TONE1 lamp turned on. The functions
assigned to the Knobs are indicated at right of the values
respectively.
Settings: -64 – +0 – +63
n The functions assigned to the ASSIGN 1/2 Knobs can be set in
the Controller Set display (page 104).
4 A. Function 1 Mode
(Assignable Function 1 Mode)
5 A. Function 2 Mode
(Assignable Function 2 Mode)
Determines whether the ASSIGNABLE FUNCTION [1] and
[2] buttons functions as a latch type or momentary type.
When set to “latch,” pressing the button alternates the
lamp status between on and off. When set to “momentary,”
pressing/holding the button turns the lamp on and
releasing the button turns the lamp off.
Settings: momentary, latch
6 Ribbon Mode (Ribbon Controller mode)
Determines the behavior of the Ribbon Controller. When set
to reset, releasing your finger from the Ribbon Controller
automatically returns the value to the center. When set to
hold, releasing your finger from the Ribbon Controller
maintains the value at the last point of contact.
Settings: hold, reset
7 ARP Common Switch
Determines whether Arpeggio is on or off. This parameter
is the same as the Common Switch parameter in the
Arpeggio display (page 139) of the Performance Play
mode.
8 ARP Sync Quantize Value
This parameter is the same as the Sync Quantize Value
parameter in the Arpeggio display (page 139) of the
Performance Play mode.
Output Level and Master Effect
settings—[F2] Level/MEF
1 Volume*
Determines the output level of the entire Performance. You
can adjust the overall volume, keeping the balance
between all Parts.
Settings: 0 – 127
2 Pan*
Determines the stereo pan position of the Performance.
You can also adjust this parameter using the PAN knob on
the front panel.
Settings: L63 (far left) – C (center) – R63 (far right)
n Note that this Performance Pan parameter may have little or no
audible effect if the Pan for a specific Part is set to the left
position and the Pan for another Part is set to the right position.
3 Reverb Send*
Adjusts the reverb send level. The higher the value the
deeper the reverb. You can also adjust this parameter
using the knob on the front panel.
Settings: 0 – 127
4 Chorus Send*
Adjusts the chorus send level. The higher the value the
deeper the chorus. You can also adjust this parameter
using the knob on the front panel.
Settings: 0 – 127
n When Reverb Send/Chorus Send is set to “0” in the
Performance Part Edit mode, the setting here is not available.
Other settings—[SF4] Other
1
2
7
8
3
4
5
6
Output Level settings—[SF1] Level
1
2
3
4