Filter
Top Products
Jacking Instructions
CAUTION
perform other service, use correct blocks,
er
jack stands, the machine may move or fall,
Jacking the Front End
vent the machine from moving.
lose to the wheel as possible to support the ma-
chine.
Figure 1
1
1
1
1
When raising the machine to change tires or to
hoists, and jacks. Make sure machine is parked
on a solid level surface such as a concrete floor.
Prior to raising machine, remove any attach-
ments that may interfere with the safe and prop-
raising of the machine. Always chock or
block wheels. Use jack stands or solid wood
blocks to support the raised machine. If the ma-
chine is not properly supported by blocks or
which may result in personal injury.
1. Set parking brake and chock both rear tires to pre-
2. Position jack securely under the front axle, directly
beneath the leaf springs (Fig. 1).
3. Jack front of machine off the ground.
4. Position jack stands or hardwood blocks under the
axle as c
1. Front jacking points
Jacking the Rear End
Figure 2
1. Rear jacking points
1. Set parking brake and chock both front tires to pre-
vent the machine from moving.
2. Place jack securely under the rear most frame sup-
ports between the angle welds (Fig. 2).
3. Jack rear of machine off the ground.
4. Position jack stands or hardwood blocks under the
frame to support the machine.
Safety and Instruction Decals
Numerous safety and instruction decals are affixed to
the Multi Pro 5700–D. If any decal becomes illegible or
damaged, install a new decal. Part numbers are listed
in your Parts Catalog. Order replacement decals from
your Authorized Toro Distributor.
Safety Page 1 – 4 Multi Pro 5700–D