Filter
Top Products
Multi Pro 5700–D
Page 5 – 27
Electrical System
Service and Repairs
NOTE: See the Kubota 05 Series Diesel Engine Ser-
vice Manual for engine electrical component repair in-
formation.
Headlights
Removal and Installation
1. Set parking brake, turn ignition off, and remove key.
2. Remove two (2) flange head screws that secure
shield to machine. Position shield away from back of
headlight.
3. Unplug wiring harness connector from headlight
bulb.
NOTE: Headlight bulb can be replaced without remov-
ing headlight body. Be careful when servicing bulb. Nev-
er touch bulb with fingers – handle bulb by the base.
4. To replace the headlight bulb:
A. Turn the bulb approximately 1/4 turn counter-
clockwise and remove bulb from headlight body.
B. Align bulb base with hole in headlight body. Insert
bulb into headlight body and turn the bulb approxi-
mately 1/4 turn clockwise.
5. If headlight body or lens requires removal, remove
three (3) screws that secure headlight assembly to ma-
chine. Remove headlight assembly. Install in reverse or-
der.
6. After repairs are completed, attach wiring harness
connector to headlight bulb.
7. Attach shield to machine with two (2) flange head
screws.
1. Headlight lens
2. Headlight body
3. Screw (3 used)
4. Headlight bulb
5. Flange head screw
6. Shield
Figure 44
1
2
3
4
6
5
5
Electrical
System