Filter
Top Products
Multi Pro 5700--DHydraulic System Page 4 -- 4
General Information
Hydraulic Hoses
Hydraulic hoses are subject to extreme conditions such
as pressure differentials during operation and exposure
to weather, sun, chemicals, very warm storage condi-
tions, or mishandling during operation and mainte-
nance. These c onditions can cause damage or
premature deterioration. Some hosesare more suscep-
tible to these conditions than others. Inspect the hoses
frequently for signs of deterioration or damage.
When replacing a hydraulic hose, be sure that the hose
is straight (not twisted) before tightening the fittings.
This can be done by observing the imprint on the hose.
Use two wrenches; hold the hose s traight with one
wrench and tighten the hose swivel nut onto the fitting
with the other wrench.
WARNING
Before disconnecting or performing any work
on hydraulic system, relieve all pressure in
system. Stop engine and rotate the steering
wheel.
Keep body and hands away from pin hole leaks
or nozzles that eject hydraulic fluid under high
pressure. Use paper or cardboard, not hands,
to search for leaks. Hydraulic fluid escaping
under pressure can have sufficient force to
penetrate the skin and cause serious injury. If
fluid is injected into the skin, it must be surgi-
cally removed within a few hours by a doctor
familiar with this type of injury. Gangrene may
result from such an injury.
Hydraulic Fitting Installation
O--Ring Face Seal
1. Make sure both threads and sealing surfaces are
free of burrs, nicks, scratches, or any foreign material.
2. Make sure the O--ring is installed and properly
seated in the groove. It is recommended that the O--ring
be replaced any time the connection is opened.
3. Lubricate the O--ring with a light coating of oil.
4. Put the tube and nut squarely into position on the
face seal end of the fitting and tighten the nut until finger
tight.
5. Mark the nut and fitting body. Hold the body with a
wrench. Useanother wrench totighten the nutto the cor-
rect Flats From Finger Tight (F.F.F.T.). The markings on
the nut and fitting body willverify that the connection has
been tightened.
Size F.F.F.T.
4 (1/4 in. nominal hose or tubing) 0.75 +
0.25
6(3/8in.) 0.75+
0.25
8(1/2in.) 0.75+
0.25
10 (5/8 in.) 1.00 +
0.25
12 (3/4 in.) 0.75 +
0.25
16 (1 in.) 0.75 +
0.25
Figure 1
Nut
Sleeve
Seal
Body
Figure 2
Mark Nut
and Body
Final
Position
Extend Line
Initial
Position
Finger Tight After Proper Tightening